Latest activity

I guess you have checked the valve clearance adjustment. Here is info for others. I would check them if you haven't. They are manually...

I guess you have checked the valve clearance adjustment. Here is info for others. I would check them if you haven't. They are manually...

I set them at .013 or 0.15 if I remember correctly

To answer your original question. It's 21 1/4" outside to outside. The rod itself is made out of 5/8" round stock. I did not meaure the...

I have to agree with Jim on the valves, either sticking, or set a little tight. They are better to be a little loose than tight which...

My only idea is maybe sticking valves.

No offense taken. Sometimes the thought and intent of a message is stated in such a way that is interpreted differently by the...

If at all possible, a video of it running with the noise and popping could help paint a better picture.

Started cleaning up the clutch pulley and cover. After getting some rust and paint off I can see the pulley is worn where the pulley...

Ok I went over the tractor again today. I messed with the carb, and checked all of the wires and coil. The coil is making a snappy...

(y) Or a standard roll pin that fits the hole with a smaller one driven into the hole of the larger pin to lock it in place. JMHO Stan

Sounds about right. As I recall the common thermostats that I have dealt with in the past start to open at about 180 degrees (or so the...

No offense taken. Sometimes the thought and intent of a message is stated in such a way that is interpreted differently by the...

If you remove the cotter pin from the rod that connects back to the lever at the operators station and the rod from the lever #11 should...

I’ll be the odd one out and say that I would spend the money and get the appropriate part. $3 is a lot but how often are you going to...