Latest activity

If you ever lose the pin, like l did once, you can replace it with the shank end of a 5/16" drill bit cut to length.

Are you using a 50/50 antifreeze mixture? I don't know the actual specs, but in my opinion if it's not boiling, you should be good.

I understand. I can't give dimensions as l don't have one, and have never used one. See my above post. No offense intended.

Thanks for the info. The pictures that I posted were just for illustrating purposes (I have a tendency to give too much info). The...

I owe Stan an appology. The manual does show an extension on the rocker arm. I've never used one. I just use the front lifting arm and...

I had contemplated installing a water temp gauge. I have a hole in the dash from where the oil pressure gauge was. I moved it to the...

MOST helpful parts diagram Thank you! With engine off and moving throttle operator lever, I do not see corresponding movement at the...

Had a nice turnout and saw a few faces that were new and a few old one had not seen in a long time,

Whn One of the causes of no throttle response is the control lever on the governor shaft is frozen up. When you are checking the...

Could be control rod/linkage binding somewhere. With engine off, move engine throttle lever back and forth and confirm that you see a...

If anybody has interest in any of the individual items, get with me and let me know and we’ll see if we can’t work something out… I do...

Hi folks, finally got the Cub back together and it starts and runs but not getting Throttle response and it idles too fast. Zenith carb...

Hi folks, finally got the Cub back together and it starts and runs but not getting Throttle response and it idles too fast. Zenith carb...

3/4” from the end to the center of the pin is correct as shown in the drawing that Stan posted. The pulley is cast iron, so unless you...

Try this. The rod stock material is 5/8 inch diameter. The last one that I made cost about $10 for materials. Stan