Don McCombs
501 Club
If you can determine what size the original coulter disks were, Agri-Supply may have replacements.
The reason I was asking about how to measure the plow is I wasn’t sure if the size of the plow would determine the coulter sizeJim Becker":1ae97xd3 said:With a multiple bottom plow, you can simply measure the spacing between adjacent beams, directly crosswise and center-to-center. Don's comment wasn't about the plow size, but the diameter of the coulter disks themselves. For a number 8 plow, the originals were probably 16", although there was an option of 18". Due to wear, your old ones will probably measure a lot less than their original size.
How does this look for adjustment?MiCarl":3r0pmeh2 said:LittleBigTires1948":3r0pmeh2 said:It was my test area and I ran outta room, I have clay and that was a hayfield with tall grass but I think I’ll widen the rear tires I think it’s too close the the next row
You don't need to widen the tires. You can shift the plow left and right by changing how the plow's hitch attaches to that crosswise bar with all the holes in it. You want to adjust the plow so the right lower corner of the right share lines up with the inside sidewall of the right tractor tire. Then when you drive with the right tire in the previous furrow the plow cuts the next furrow right against it.
Don't be tempted to cheat by moving the clevis along the draw bar. That pull from the plow will try to steer the tractor and you'll end up fighting it. For that matter, I wonder if it might be better not to use the swinging draw bar with the plow. Someone who knows more about that might weigh in.
LittleBigTires1948":36ulyexm said:How does this look for adjustment?
It may be because it’s raised up and both were not at the same setting. And I think the photo Was taken at an angle and since they are not next to each other it appears that way, they are exactly how they were when I got it but I’ll check it with a level tomorrowDon McCombs":2nhnke1k said:It may be camera angle or optical illusion, but the right hand bottom (as seen in the photo) appears to be set higher than the other one. Is that correct?
LittleBigTires1948":1kh1e08r said:I’ll check it with a level tomorrow
:mrgreen: I’ve heard about that, in fact a guy tore his seat off because he used some sorta 800 pound para cord and had no release mechanism I think it was on a super a and however the seat was attached was so rotted it failed.this happened on my buddy’s farm and his dad had a hell of a time running after the tractor and hitting the ignition.John *.?-!.* cub owner":o2u3957y said:If you want some fun, be pulling that trip rope to raise the plow when it catches a rock and breaks away. It is amazing how long your arm can get before your mind tells you to let go. :roll:
Ok good, I was kinda worried about that if i was plowing and my tires for some reason has more traction than normal I’d flip backwards, for all my tests I have had my foot hovering over the clutch just in case.MiCarl":191ksrwq said:I doubt it'd be stuck hard enough to not trip if it needs to.
I've done a little plowing with an H that has a single set of rear weights and a John Deere 2-14 plow. The only time the plow tripped off is when another operator dropped the clutch (he just cannot seem to feather a clutch!). We did manage to get wheel spin while plowing without it tripping off.