Latest activity

You must have removed the spring lever that the spring is attached to. The governor rockshaft will not come out without removing the...

That piece that you removed from the governor is the governor spring lever, not the rockshaft. There is no gasket that belongs there...

Hi, all. I'm taking the leap into refurbishing our 1948 Farmall Cub that has been in the extended family since it was new. It actually...

The clutch operating rod on this tractor looks like a homemade replacement. It is made out of 1/2" round stock and they tacked another...

I got the shaft out I had thought it would come out of the governor housing. So the oil leaks out the housing along the shaft in the...

attempting to put in a new rockshaft gasket but the shaft only pulls out about .5 inch. I don’t see a woodruff key

What stan said will get you started in the right direction for both questions. Come back here for any additional questions or needed...

Good morning all from the cool deep south . I am a bit surprised how long its been since starting this project ( motor blew out in early...

Good morning all from the cool deep south . I am a bit surprised how long its been since starting this project ( motor blew out in early...

Good morning all from the cool deep south . I am a bit surprised how long its been since starting this project ( motor blew out in early...

You can check the available manuals located at the Resources tab at the top of this page for service and repair manuals that are...

Hello from Belgium. I'm doing my Farmall Cub engine. I'm done with the mechanical part. Have to start with the settings from the...

The 3 or 4 most rear bolts (the ones hidden behind the flywheel cover) screw into the rear main seal holder. This material is made out...

Before you install the new seals, make sure that there are no burrs or scratches where the seal is seated that might gouge the seal...

Hi, I sent you a message, you get to it at the upper right of the page.