A similar problem. My '49 Cub (6V magneto) died while idling and have been unable to restart it. Fuel is not the problem. Pulled a plug and saw it is sparking, but the spark seems weak. Not the least bit of a pop when cranking. Prior to dying it had a bit of misfiring when idling but not under load. Not good with electrics and am mystified.
There are 2 different ignitions being discussed in this post.
nhess22, the Battery Ignition point gap is .020"
capefarm, the magneto point gap is .013"
Both when the movable point is on the high part of the cam.
I would do the spark test that I posted above, it is easy to do.
Capefarm, the magneto is not hard to work on. The 1949 Cub owner's manual tells how to check or replace the points. The points burn from use, and eventually the engine won't run if nobody has checked them for years.
NAPA has new points, they are CS1600.
The condenser may have gone bad too.
The old original coils commonly quit, some get weak and don't make enough spark for the engine to run.
TM Tractor Parts has a new magneto coil, they are different than a car coil from the past. The coil is under the cover on top of the magneto.
Below is their listing for it, you can look at the pictures. I would begin by checking the points.
I sent you a message.
TM Tractor Parts for McCormick Farmall Cub, International Cub, and International Lo-Boy
Below is a picture of the magneto points and condenser.
The 2nd picture is the rotor drive gears. When the cover is off, you can clean the area, and grease the gears. Check the gear teeth for wear, if they are worn lots, the rotor and drive gear should be replaced. TM Tractor Parts has those.
Check the timing marks on the 2 gears, they should be aligned.