Stumped.

Harold R

501 Club
I'm helping to replace a hot water tank in a mobile home, and I've ran into a problem with the size of pvc pipe on the hot water side. There was conventional 1/2" sched. 40 pvc stubbed up through the floor for the cold water side, and that all reconnected fine, but the hot water side "looked" like 1/2 pvc, but was slightly tan in color, and will not accept a standard 1/2" pvc coupling.
Seems to be just a hair bigger O.D. than the I.D. of the standard coupling. It is a 40 gallon electric tank, same size as what was in it, but the entry and exit points were located at the top of the tank, instead of the original tank, cold water on the bottom, and hot water on the side near the top. I thought it was CPVC, but it looks like that has the same size standards as PVC. I looked into PEX...which seems to be the new standard for mobile home water line, but that is either gray or red in color and is pliable. Anybody have an idea what I'm dealing with? Home Depot and Lowes have nothing similar. :roll:
 
PVC is not suitable for hot water. The smaller pipe is CPVC. Different size from the PVC. It uses a different cement. The cement for CPVC will be orange or yellow. Be sure to use the primer before the cement. Do not use a multi-purpose cement. For CPVC pipe, buy the FlowGard Gold as it is much better quality.
 
Just got back from the plumbing supply store, and you are exactly right. I found everything I needed. CPVC is what was used, except the tank fittings, and those were copper. Thanks for your help. 8)
 
Home Depot probably had what I needed when I first looked, but I was trying to fit regular PVC to CPVC. The plumbing supply guy said they make an adapter but you can't use it for hot water and pass a plumbing inspection.
 
Back
Top