I'm helping to replace a hot water tank in a mobile home, and I've ran into a problem with the size of pvc pipe on the hot water side. There was conventional 1/2" sched. 40 pvc stubbed up through the floor for the cold water side, and that all reconnected fine, but the hot water side "looked" like 1/2 pvc, but was slightly tan in color, and will not accept a standard 1/2" pvc coupling.
Seems to be just a hair bigger O.D. than the I.D. of the standard coupling. It is a 40 gallon electric tank, same size as what was in it, but the entry and exit points were located at the top of the tank, instead of the original tank, cold water on the bottom, and hot water on the side near the top. I thought it was CPVC, but it looks like that has the same size standards as PVC. I looked into PEX...which seems to be the new standard for mobile home water line, but that is either gray or red in color and is pliable. Anybody have an idea what I'm dealing with? Home Depot and Lowes have nothing similar. :roll:
Seems to be just a hair bigger O.D. than the I.D. of the standard coupling. It is a 40 gallon electric tank, same size as what was in it, but the entry and exit points were located at the top of the tank, instead of the original tank, cold water on the bottom, and hot water on the side near the top. I thought it was CPVC, but it looks like that has the same size standards as PVC. I looked into PEX...which seems to be the new standard for mobile home water line, but that is either gray or red in color and is pliable. Anybody have an idea what I'm dealing with? Home Depot and Lowes have nothing similar. :roll: