One of the most interesting things on a Cub is replacing the governor spring. It's just a little spring about an inch long and in plain sight with the hood/tank off. Expensive little thing too. Some special tools are required so have every thing at your fingertips. Special tools include long nose pliers, long nose vice- grips, a 2' long screwdriver or pry bar, 3' of bailing wire, duct tape, and your favorite refreshment to steady your hands. The duct tape is for holding the governor extension in the rear most position and the bailing wire is for pulling the spring up that last 1/16 inch. The long screwdriver is to help pull up the wire attached to the spring, it's a strong little devil. The other tools are self explanatory. One last thing. Be prepared to spend up to to 1 1/2 hour straddling the right front tire. This would not be a good project for a Cub Fest because there is no room for observers. :wink: