Some things never change

DanR

501 Club
One of the most interesting things on a Cub is replacing the governor spring. It's just a little spring about an inch long and in plain sight with the hood/tank off. Expensive little thing too. Some special tools are required so have every thing at your fingertips. Special tools include long nose pliers, long nose vice- grips, a 2' long screwdriver or pry bar, 3' of bailing wire, duct tape, and your favorite refreshment to steady your hands. The duct tape is for holding the governor extension in the rear most position and the bailing wire is for pulling the spring up that last 1/16 inch. The long screwdriver is to help pull up the wire attached to the spring, it's a strong little devil. The other tools are self explanatory. One last thing. Be prepared to spend up to to 1 1/2 hour straddling the right front tire. This would not be a good project for a Cub Fest because there is no room for observers. :wink:
 
:lol: I've put a couple of these on myself and it's a real pain sometimes. I really recomend it though because it makes the governor system work so much better. On my first one I cut about 1/8 inch off the ends of the hooks. I then placed the top one on and pulled the bottom one down by a wire through the bolster opening and slipped it on with a screw driver.
After that one I learned to do this while all the fronts off. :wink:
Like I said, it would be worth it to me to remove the whole front just to replace this spring... It makes that much difference. :wink:
 
Is this spring something I should consider replacing?
My Cub's going to the LA Cubfest next month, and the front end will be off to replace the crank pulley.
Hopefully, the front end will never have to come off again because it's a bigger job than I feel safe doing myself.
The engine really hasn't run long enough for me to know if it's bad or not.
The throttle lever was stuck, but came loose with PB Blaster.
I'd sure hate to find out it needs replacing once it's back home with the front end back on.
I wouldn't mind going ahead and getting one, but I don't know what TM's policy is on returns.
Maybe I'm worrying about stuff I don't need to, but I'd like to cover my bases and I don't have any experience with governors.
 
Thanks Bigdog. It's hard to tell sometimes if I'm thinking of good preventive maintenance or just wasting my time. :)
I'll give TM a call.
Can y'all thing of anything else? Like I said, I don't plan on having the front end off again.
 
"While you have the hood off"

:bellylaugh: :bellylaugh: :bellylaugh:

Ronny,
Just make sure of one of the following;
1) Ralph is in attendance.
2) There's a Case/IH Dealer nearby.
3) TM Tractor has their trailer loaded with goodies onsite.

You just never know what you'll find with the hood off.
Seriously,
I would plan on replacing the upper and lower hoses. When we did my front seal at CubFest 2006 we discovered that the hoses were shot. Fortunately George Willer was kind enough to trade me a set of hoses from the raffle prizes he brought.
It's a good time to change the plugs & wires and fan belt too.
Have fun in Louisiana.

Peter
 
Back
Top