I mentioned in an earlier post that I had been given a very old metal lathe, which appears to be a 9 inch Atlas.
I'm currently in the process of soaking out old hardened grease, removing rust prior to painting, finding broken part replacements, etc (sounds just like another Cub project, doesen't it?) and have picked up a couple books on metal lathe work. From what I've read, the tool bits have to be ground very specifically for what you wish to do, and with very specific angles, back cuts, etc required to do it right. Frankly it sounds extremely complex! Unfortunately the books (Atlas, and Lindsey's South Bend) I found have really small photos of what they're talking about, and illustrate countless configurations.
How do you learn how to do this? Are there good books with huge photos that take you thru grinding the bits step by step? Can you buy ready made bits . . . perhaps I could use them as a sample to work from? (As you can see from the photo, the lathe has a sort of carousel arrangement that holds 4 cutting bits. I recall GW pointed out the last time that this arrangement is better than the lantern or Armstrong schemes.)
But where do you start? I would appreciate any suggestions on how to begin learning this. I've never done this before! Help!
P.S. for George Willer: My 340 has disc brakes . . . there are two cast disc's inside each housing, probably the same as with your Super M, and they're pretty glazed. It occurred to me that maybe (if I ever learn how to make a cutting bit, that is) I cut them on this lathe like you would on an brake lathe? Have you ever done this? Would it be worth doing?
I'm currently in the process of soaking out old hardened grease, removing rust prior to painting, finding broken part replacements, etc (sounds just like another Cub project, doesen't it?) and have picked up a couple books on metal lathe work. From what I've read, the tool bits have to be ground very specifically for what you wish to do, and with very specific angles, back cuts, etc required to do it right. Frankly it sounds extremely complex! Unfortunately the books (Atlas, and Lindsey's South Bend) I found have really small photos of what they're talking about, and illustrate countless configurations.
How do you learn how to do this? Are there good books with huge photos that take you thru grinding the bits step by step? Can you buy ready made bits . . . perhaps I could use them as a sample to work from? (As you can see from the photo, the lathe has a sort of carousel arrangement that holds 4 cutting bits. I recall GW pointed out the last time that this arrangement is better than the lantern or Armstrong schemes.)
But where do you start? I would appreciate any suggestions on how to begin learning this. I've never done this before! Help!
P.S. for George Willer: My 340 has disc brakes . . . there are two cast disc's inside each housing, probably the same as with your Super M, and they're pretty glazed. It occurred to me that maybe (if I ever learn how to make a cutting bit, that is) I cut them on this lathe like you would on an brake lathe? Have you ever done this? Would it be worth doing?