Watch
http://www.midwayusa.com for sales and deals on the LEE starter reloading kits too. I also like the LEE case trimmers we use with a battery operated drill. Your going to need a case tumbler too. I use the frankfort vibrator for case tumbling. (midwayusa has these on sale at times too)
I'm using the smaller LEE presses for secondary work on the brass. They have been awesome too. (decapping with the LEE decapper die. I'm sure the larger LEE press will serve you well and won't break the bank buying it. I been buying up the LEE RGB dies too. The 308win RGB dies was only $9 at onetime and we flew 5k of 308win thru it twice now. The LEE dipping cups help out too. I pick the next size smaller cup size thats under my load and then use the powder trickler to make each load exactly the same. I ran all the 308win this way. I have over 10k of match grade ammo. Bill
Right now were just shooting my 1978 45acp ammo that i reloaded way back then. It all goes bang like the day i reloaded it. I have some surplus 8mm turkish fmj ammo dated 1937 that all fires off too. My point is the shelf life on ammo is many, many years. I do store it all in 50cal ammo cans so there dry.
My reloading process;
1st. Decap the brass
2nd Polish the brass with the coarse media
3rd. Lube & Resize the brass
4th Wipe the lube off the resized brass
5th Trim the brass to its orginal length
6th Clean out the primer pockets
7th Back to the polisher with the fine media and brass polish
8th Inspec the primer pockets for media stuck in them and make sure the inside of the cases are free of media
10th Prime cases
11th Look in the reloading book for a powder weight for the bullet your using and Charge the cases with gun powder( you can weight each load or set the powder dispensor to that powder weight) I check and double check the powder dispensor before the run, during the run to make sure its still correct. Remember to zero the scale before you set the powder weight.
12th Insert the bullet and seat it.(if you need a crimp most dies will do it once you set the bullet dept you can back off on the seater rod and lower the die a tad to add a crimp then while the arm on the press is down set the seater rod to the bullet thats already set and lock it. Then try one round to see if its all set correctly, if it is run them.
No 1 rule don't talk to anyone while reloading, no distractions, no mistakes. If your powder charging leave no unopened cans of powder nearby while reloading and clean up all the spilled powder on your table when your done. Clean up the4 floor too. Do not use a vaccumne cleaner use a dust pan and a brush. besafe do it right and proceed with caution. Bill