overdrive

brichter

501 Club
Okay I have a question for you mechanics and truck guys. I have a 2002 2500 HD Silverado. I normally drive around 55 MPH and get about 20 MPG. I put a truck camper on it this past week and then we went to visit Mary Lou's new Great Grandson. I pushed the button to disable the overdrive just like the book said. My mileage plummeted to 12.5. My engine seemed to be revving all the time through the gears. about 30 miles from home we stopped for a break and when we left out again I didn't push the button and used the overdrive. The truck performed perfectly. My question is, will it actually hurt the truck to use the overdrive or should I disable it when the camper is on?
 
I am not an automatic transmission expert, but in overdrive with a high load won't the transmission have to slip? This produces heat and wears on the components faster. If it worked ok it probably isnt a high enough load to cause this becuase it should drop a gear if the load is too great. I know with my manual transmission I have heard that I should pull in 4th becuase the gear is physically stronger than the overdrive gear. Could be?
 
BR,

I'm not sure, but I had a 2000 Suburban and a 1999 Silverado (both 1500's) and I thought the 2500's were the same. There was the "Tow/Haul" button on the end of the gear shift lever and two "Drives" on the dashboard gearshift quadrant. It sounds like you were pushing the "Tow/Haul" button on the gearshift. That raises the shifting points of each gear dramatically for pulling heavy loads. It may lock out the overdrive, but I don't remember. Of the two "drives" on the gearshift quadrant, "drive 1" (right) is regular drive and "drive 2" (left) is overdrive. I was always told to pull it down to "drive 1" when towing a trailer so that it wasn't always "hunting" between overdrive and "drive". If the load wasn't excessive I would use overdrive. I never did like using the "Tow/Haul" feature. My loads never seemed to me to need the excessive rpm's it created.

I don't think you need the "Tow/Haul" feature for standard driving with an onboard camper given the strength of your engine and the moderate speeds you drive. If you have strong headwinds and/or the transmission starts shifting in and out of overdrive you should pull it down to "drive 1". But, in any case, you won't get your 20 mpg with the camper without a good tailwind. :big say what:
 
Billy Ray,

Just an opinion, because I know more about older vehicles than today's computerized vehicles. But I think the answer depends on how hard you are working your transmission. If you are able to drive highway speeds without "hunting" between the gears, I would continue to use overdrive on highways. If you are right in that area where the transmission wants to go to overdrive but the load won't let it stay there, then drop it out.

My wife's suburban has the "tow haul" button on the end of the gear shift, and I thought it only affected shift points. In the mountains it might be useful, but I've never used it....
 
Iwill try to rationalize the use of Overdrive in an auto trans, without flubber-dubbing everything and everybody up (Anyone remember Flubber Dub?) When your driving down the road in any vehicle with any trans, carrying any load, You should be traveling in high gear on a fairly level road. I f you speed decreases for any reason, such as a hill or traffic, your engine will slow proportionatly with your speed. If you do not change gears (either manually or automatically) your engine will drop below its "power curve" and beigin to "lug" putting excessive strain on the drivetrain. When your engine is "lugging" applying more throttle is absolutely the WORSE thing you can do, You must change to a lower gear. Back when O.D. auto trans first came upon the market. Drivers would just mash down on the throttle, and promptly disintergrate the trans. Ford went so nuts with this problem back in the 80s that they almost stopped offering O.D. auto trans in trucks. They went back to the drawing board and made improvements which eventually evolved into the trannys we use now with the manual O.D. disconnect in addition to the computerized setup inside the tranny. I have been towing with O.D. trannys since they came out, without problems, but you must anticipate hills and downshift the trans keeping those engine R.P.M.s in the "sweet spot". Towing on the flat in O.D. will not adversely affect anything. JMHO Frank
 
The engine revving higher that usual is the tow-haul programming doing it's job. The increased fuel consumption is the weight of the camper and additional drag, make sure you increase the air pressure in the rear tires to compensate for all that weight. Your Allison tranny is a 5 speed auto, it should use all 5 forward gears even in tow-haul. The newer 6 speed locks out the 2nd overdrive in tow-haul.
 
Back
Top