Iwill try to rationalize the use of Overdrive in an auto trans, without flubber-dubbing everything and everybody up (Anyone remember Flubber Dub?) When your driving down the road in any vehicle with any trans, carrying any load, You should be traveling in high gear on a fairly level road. I f you speed decreases for any reason, such as a hill or traffic, your engine will slow proportionatly with your speed. If you do not change gears (either manually or automatically) your engine will drop below its "power curve" and beigin to "lug" putting excessive strain on the drivetrain. When your engine is "lugging" applying more throttle is absolutely the WORSE thing you can do, You must change to a lower gear. Back when O.D. auto trans first came upon the market. Drivers would just mash down on the throttle, and promptly disintergrate the trans. Ford went so nuts with this problem back in the 80s that they almost stopped offering O.D. auto trans in trucks. They went back to the drawing board and made improvements which eventually evolved into the trannys we use now with the manual O.D. disconnect in addition to the computerized setup inside the tranny. I have been towing with O.D. trannys since they came out, without problems, but you must anticipate hills and downshift the trans keeping those engine R.P.M.s in the "sweet spot". Towing on the flat in O.D. will not adversely affect anything. JMHO Frank