Help!!
After spending more time than I care to admit refitting the wooden handle on a wood splitting maul that had been given me, after a few hits it's loose!
$%#@^ !!
This was my first time refitting a maul handle. After removing the previously damaged handle, I cut off 4 or 5 inches of it till I had good wood, shaped the new end till it fit tightly into the head using a belt sander, made a slot in the end, drove the handle into the head, and hammered two steel wedges in. It felt tight at that point. However after a few log splits, there was a definite wobble. Guess I need a better method.
Can someone share their technique?
By the way, do most prefer wood or fiberglass handles? The one given me has an 8 lb head. Is that a standard weight?
I'd appreciate any techniques and suggestions. Thanks!
Paul
After spending more time than I care to admit refitting the wooden handle on a wood splitting maul that had been given me, after a few hits it's loose!
$%#@^ !!
This was my first time refitting a maul handle. After removing the previously damaged handle, I cut off 4 or 5 inches of it till I had good wood, shaped the new end till it fit tightly into the head using a belt sander, made a slot in the end, drove the handle into the head, and hammered two steel wedges in. It felt tight at that point. However after a few log splits, there was a definite wobble. Guess I need a better method.
Can someone share their technique?
By the way, do most prefer wood or fiberglass handles? The one given me has an 8 lb head. Is that a standard weight?
I'd appreciate any techniques and suggestions. Thanks!
Paul