Maul Handle Replacement ??

Paul_NJ

501 Club
Help!!

After spending more time than I care to admit refitting the wooden handle on a wood splitting maul that had been given me, after a few hits it's loose!

$%#@^ !!

This was my first time refitting a maul handle. After removing the previously damaged handle, I cut off 4 or 5 inches of it till I had good wood, shaped the new end till it fit tightly into the head using a belt sander, made a slot in the end, drove the handle into the head, and hammered two steel wedges in. It felt tight at that point. However after a few log splits, there was a definite wobble. Guess I need a better method.

Can someone share their technique?

By the way, do most prefer wood or fiberglass handles? The one given me has an 8 lb head. Is that a standard weight?

I'd appreciate any techniques and suggestions. Thanks!

Paul
 
I broke two wooden handles on a 8 pound maul and then put on a fiberglass one its been great. That was over twenty years ago by the way.
 
I have broken a few axe and maul handles in my time then switched to fiberglass but still have to old ones around. The last time I broke the handle on by double bit axe I put on the new handle then from the axe head down about 5" I wrapped it with a coil of steel wire.

Mauls break more often when used with wedges to split wood. You have to be creative on how you wrap the wire but it is much harder to break the new handle if they are wrapped. Start out with a leingth of wire going down the handle (about 5") and up to the head then bend it and go under the bend and the opposite way-start wrapping in the coil down to the lower end of the wire. When you finish the leinght tuck the wire into the last coil and curl it around (Under) a few times and pull it tight. At this point it might be good to wrap it up with duct tape or something so you don't snag you hand on the cut off end of the wire. You can miss the wedge many times and not break the handle.

The last time I broke a handle I had the broken one in the back seat of the car and got stopped by the cops. The officer didn't like the axe handle in the back seat and asked me why it was there--"because officer, I broke it and need to get a new one"--that was easier to explain than the rifle laying on the back seat. The last time I was stopped was 3 years ago and that wasn't too good either as I had a bloody knife and hatchet in the truck seat. I do wildlife control for a University and had been working on deer problems in a research area the night before, I work nights and was up with only 2 hours sleep to go into the office for a meeting. By the time I was done telling him what I was doing and had been doing he was laughing and told me to be on my way but clean up the knife and hatchet and put them away. Helps that I worked for the cops for 10 years and don't now but still report to them each night.

Tim Moore--

wrap those handles with wire and they are hard to break.
 
I have done a number of handles through the years. I drive a wooden wedge lengthwise and 2 or 3 steel wedges crosswise. Some holes in the head are sort of wollered so you may have to drive the steel wedges a bit closer to the end.
 
Put another wedge in next to the one in there now. Also if you put it in a bucket of water before you use it will swell up tight.
Now a days it's about the same to buy a new one as it is to buy just a handle.

DanR":3k65o732 said:
The only sure fix is to get one that is gasoline powered. :P

:Dito: To what Dan said
 
Back
Top