John Deere 60 repair

Enjoy the anticipation when you stomp on that starter pedal! It'll start...you know too much for it not to.
I too put in a 1 wire alternator and I made it simple...I went from the alternator to an on off switch straight to the battery. I have the switch to stop any vampire malarkey and can charge when I need to. No magneto cut off. Looking forward to hearing it run
 
ajhbike":3jma326t said:
Enjoy the anticipation when you stomp on that starter pedal! It'll start...you know too much for it not to.
I too put in a 1 wire alternator and I made it simple...I went from the alternator to an on off switch straight to the battery. I have the switch to stop any vampire malarkey and can charge when I need to. No magneto cut off. Looking forward to hearing it run

:thanx: I hope your right. Hopefully I don't have to chase leaks or other gremlins once its going. Dad would often put in a pressure switch in an oil line to cut power so you don't end up with a dead battery. We'll see if we need something like that on this one.
 
Miracles do happen. The JD 60 runs again after 25 years. After filling the carb with fuel and the radiator with water it popped on the first revolution of the starter and after choking for a couple turns it came to life. It seems to rum good. The oil pressure came up right away and the charging system is working. When filling the radiator, we noticed the water pump was leaking out the weep hole. After running for a while, it is still leaking so my cousin is going to order a new one along with a new exhaust pipe. I guess after 25 years some things are going to get lost. Need to finish tidying up the wiring, change out the water pump, and get the steering shaft, hood, and grille installed and then maybe it can go home.

[youtube]m088N1CsrLE[/youtube]
 
Congratulations!! A job well done, you should be proud! I do think you failed with the subject title... "repair" .... what an understatement!

Thanks for all the pictures and documentation, it was enjoyable to follow,
 
dgrapes59":2vf5uvqz said:
Congratulations!! A job well done, you should be proud! I do think you failed with the subject title... "repair" .... what an understatement!

Thanks for all the pictures and documentation, it was enjoyable to follow,

:thanx: The project did grow quite a bit from what we originally talked about. I'm just glad to get to this point where its running again.
 
That sounds really good! By the time JD was building the 50/60 series tractors, they were much more refined than previous models and can be seen in the smoothness of your 60 projects idle.
 
:thanx: for the kind comments. I need to make a change in the wiring for the alternator. As it is right now it feeds back and keeps the coil powered up so the tractor doesn't shut off with the switch. Had to pull one wire off the alternator to kill it. I'll be adding a pressure switch to separate the alt. from the coil power at the switch. I think the same thing can be accomplished with a diode also, but I am more familiar with the pressure switch setup.
 
Since I already had the pressure switch in hand I went ahead and installed it. The tractor shuts off with the switch now and in the process, it got a new oil line to replace the old rust pitted one. Next time I run into this I will try putting in a diode.

100_5291-m.jpg
 
Got a new water pump, painted it up, installed it, and found it has a casting flaw that leaks water. With haying started now I just won't have much time for this project, so my cousin said to run it over to his place and he can finish it up when a new pump arrives. He is right across the road so I was able to run it over on the small remote tank. I drove it around in the driveway for a short shakedown cruise to check for any other leaks. Now I need to get his John Deere 40 hood painted now that my paint booth doesn't have a tractor parked in it.

100_5317-m.jpg100_5320-m.jpg100_5322-m.jpg100_5323-m.jpg
 
ricky racer":22i8hc2m said:
The tractor sounds great and should be a real workhorse for your cousin! :{_}:

:thanx: When he gets it all back together he wants to plow up a 4 acre field so I will try to get some video of it working.
 
Back
Top