I made a major mistake when rototilling an area in our garden. I was going for the last pass and took a shortcut, and I snagged a 2" hose that goes to an irrigation hand line. I forgot that the rototiller tines barely clear the ground on the Cub Cadet and I pulled the hose several feet before I realized what was happening. Big oops! Water was gushing, so I jumped off the Cadet and shut off the water supply. I had pulled the aluminum irrigation pipes several feet, which is no problem. Fortunately the tiller was not rotating when I did this stunt and the 2" hose is ok. However, I did snap off a 2" main line valve and broke the riser. :evil: Once the water drained away I dug the pipe out to see what other damage I'd done. My worst fears were confirmed: I had cracked the T fitting and broken the main 2" line.
I went through my spare PVC pipe parts and fittings and discovered I had to make a quick trip to the farm supply store in town. By the time I got home there wasn't enough time left to repair the pipe before I had to leave for work. I left the irrigation water shut off overnight and started on the project the next morning. All went well, except at the end I realized I had cut about 1 inch too much off the PVC main line.
Once more there wasn't enough time to fix my error before I had to leave for work, so I just left it with a slight leak so my wife could water the new grass we planted a few days ago. This morning I spliced in an extra bit of PVC pipe and all is well. PVC is a lot more forgiving than steel pipe and is SO much easier to work with. I work in ammonia refrigeration in a food processing plant and all of our piping is in very heavy duty metal pipe, so I appreciate the ease of PVC. I guess the moral of the story is don't take shortcuts with tractors and pay attention to your surroundings. It's really easy to snag a pipe, run over a riser with a Cub Cadet or slice off a riser with a Cub and a 22 sickle mower. Guess how I learned that?