ethanol

  • Thread starter Thread starter Anonymous
  • Start date Start date
Tom:

Willkommen zuruck meine freunde... welcome back Tom.. Gawd, it is good to read one of your missives again :!: I have been lonely.. missing all the good stuff that some how you manage to cram into a single post.. inspiring.

And yes Tom.. will you be able to make it to Cecil's? Em and I are coming and I would love to sit down and chew the fat so to speak :roll: :shock: 8) :wink: 8) :lol: :lol:
 
Hey Boiz....

The only thing that I'd caution everyone about is that you all take some of these articles (especially in hard print) with a grain of salt....

There is an awful lot of politics in the press as we all know....some of it liberal, some of it conservative......in neither case is it an accurate portrayal of the truth.

The way I generally arrive at my conclusion is to gather the data from articles and internet sources, and do the math myself......you will find that the truth usually lies somewhere in between what the press is telling you.

Carl, for example, frequently quotes articles that take the very worst case scenario on ethanol.....that doesn't mean they are actually lying...it just means that the data they are using for their article comes from the very worst process that they could find. It is a good illustration, however of just how inefficient Ethanol from Corn can be.

Other articles (and government data) mislead you in the other direction, because the people who write them or supply the data have their own agenda, making you think that you can drive from NYC to LA on 3 cobs of corn.........

The truth, however, is somewhere in between, but it's still not good on the corn issue.

If we grew syrup corn instead of grain corn, by the hundreds of thousands of acres, we'd find that corn would work pretty well.......but of course, then ADM and Con-Agra wouldn't be able to demand the ridiculous amount of money they do for high-fructose corn syrup that they sell to virtually every food manufacturer in the US under controlled prices that amount to highway robbery.

But that's another story....

Not sure about Cecil's yet......We shall see......
 
Richard (Little Indy) wrote:

Brazil has been using E85 for a long time. Their consumers have a choice. E85 or straight gas. I am sure they now use a sensor to detect the amount of gas in the fuel but I don't know what they did many years ago BC (Before Computers). But whatever it was worked.
Richard,

You are correct. The problem is EPA man dates for clean air. The on board computers are for managing engine control for emissions. You have to keep the air/fuel ratio 14.7 to 1 for maximum efficiency and that can’t be done (that I know of) without an on board Engine Control Module. Any fuel/air mixture less than 14.7 to 1 is considered to be a rich mixture, any more than 14.7 to 1 is a lean mixture .


Tom wrote:

Well, you know a topic like this has to draw me out from under my rock......

LOOK WHAT CAME OUT OF THE HILLS? I knew if a topic like this was started you would “come home”. Nice to hear from you!!! Now how about some editorials to get things going :!: :!: :wink: :twisted:

Billy wrote:

Their is a fuel density sensor in the gas tank of E-85 cars.


Billy,

E85 compatible vehicles no longer use an alcohol sensor to determine and adjust for the alcohol content of the fuel in the tank. Instead, the vehicle calculates the alcohol content of the fuel through measured adjustments.
The ethanol calculation occurs with the engine running after a refueling event has been detected via a measured change in the fuel level sender output. The virtual flex fuel sensor (V-FFS) algorithm temporarily closes the canister purge valve for a few seconds and monitors information from the closed loop fuel trim system to calculate the ethanol content. This logic executes several times until the ethanol calculation is deemed to be stable. This may take several minutes under low fuel flow conditions such as idle, or a shorter time during higher fuel flow, off-idle conditions.
Air-fuel ratios and the corresponding ethanol percentage are updated following each purge-off sequence. the fuel alcohol content percentage value can be read on a scan tool.
When an E85 compatible vehicle is built, an ECM or PCM replaced, or if the learned alcohol content has been reset with a scan tool the fuel system will need to contain ASTM gasoline with 10% or less ethanol content.
A minimum of 7.5 Liters (2 gallons) must be put in the tank in order for the vehicle to recognize a re-fueling event. It is not necessary to turn the ignition off in order to have the re-fueling event recognized; however local safety regulations should be followed.
After the re-fueling event, the system registers the amount of fuel that was added, relative to the amount that was in the tank. Reading fuel trim and O2 sensor activity, the system determines if the fuel added was either ASTM Gasoline or ASTM E85. Based on that determination, the system adjusts to the expected alcohol mix in the fuel tank, and then the fuel trim and O2 sensor activity fine tunes the adjustments. The system must remain in closed loop in order for this adjustment to occur. Numerous short trips after switching from gasoline to E85, or E85 to gasoline, can result in drivability symptoms due to the inability of the system to adjust for fuel composition by not attaining closed loop operation.
As you can read the problem is from switching back and forth on fuels, not the ethanol in the fuel.

Tom wrote:

We simply need to make E85 work.......or even E100.......why not....we have the technology to do it........in 10 years, half of the vehicles on the road today will be replaced with newer machines....if E85 were mandated today, we'd be halfway there in plenty of time.

E-100 would probably work better after the engineers designed an engine just for ethanol. I drive a flex fuel vehicle and I notice no difference.

Tom wrote:
"Think outside the cornfield"!!!!!!!

Tom, what is this talk about “switchgrass”?
 
Don't know how I missed this thread, well...yes I do :lol: :lol: Very glad to see you back, Tom :!: :!: I hope you are well :!:
8)
 
Yep Tom, it is good to hear from you again! And it would be great to see you and your family again at Cecil's......

I am still concerned about the hygroscopic properties of ethanol, especially with a vented tank where the fuel could sit for a long period to time.

For most of the 'ethanol' story I revert to my libertarian side..... let the marketplace decide.
 
Billy,

Here are two tables courtesy of journeytoforever.com regarding ethanol feedstocks. The first is by the ton, the second by the acre, yield....


1Table2.gif


1Table3.gif



You can see why I advocate the Jerusalem Artichoke, which is actually a perennial sunflower. It needs no replanting, just a fall dressing of horse manure, and it just continues to propagate every year.
 
Back
Top