I finally got an air compressor that I feel will be adequate to run some tools in my shop. I had been using a direct drive Coleman Black Max 27 gallon, but it was barely able to run my die grinder or my impact wrench with out running constantly. And.....it was very noisy. My question is about some recommendations on setting up the air line exiting the tank. I believe it's a 1 inch NPT exit. I would like to have a ball valve shut-off, water separator/filter, and a regulator. I'm not going to plumb it all through the shop, just one line with a quick disconnect. Any hints or tips would be appreciate because I want to do this right, and not have to worry with it any more. Not sure it's necessary, but I will be bolting it to the floor.