SUPER dumb question here,----- The IH 2444 on the C-80 mower dies after the gas gets hot. pull line to carb off and no gas,---hold it for a few seconds and gas comes again, ---- good for a few hundred feet and dead again. Gas boils in the tank even with the heat gauge running at 180 to 220. Rad never boils, fins cleaned every time I mow.
Question here is, ---- I put an electric fuel pump on it yesterday and hooked it to the coil feed wire so it would run only with the key on and it ran 5 mins and pump died. Did the coil backfeed into the pump? OR the $2. chimineeese pump just junk out of the box? I have the same pumps on about everything I own and have never got a bad one.
I can run a wire direct to batt. and use an alligator clip for a switch. Cant get to any of the wires under the dash to hook directly to the key switch.
About ready to mount a tank behind the seat and not use the factory tank and try that.
Tractor runs fine til gas gets hot. It will run longer if I dump a gallon of real diesel fuel with 4 gallons of gas but still die. The mower dont pull all that hard and mowing roadsides and waterways I mostly run in second gear on the low side. If grass is shorter or thin I run in third and dont matter if half throttle or hammer down,--- still dies.
I moved the coil out a bit thinking that was the trouble then found the gas flow was the cause.
Open to ideas here!
Question here is, ---- I put an electric fuel pump on it yesterday and hooked it to the coil feed wire so it would run only with the key on and it ran 5 mins and pump died. Did the coil backfeed into the pump? OR the $2. chimineeese pump just junk out of the box? I have the same pumps on about everything I own and have never got a bad one.
I can run a wire direct to batt. and use an alligator clip for a switch. Cant get to any of the wires under the dash to hook directly to the key switch.
About ready to mount a tank behind the seat and not use the factory tank and try that.
Tractor runs fine til gas gets hot. It will run longer if I dump a gallon of real diesel fuel with 4 gallons of gas but still die. The mower dont pull all that hard and mowing roadsides and waterways I mostly run in second gear on the low side. If grass is shorter or thin I run in third and dont matter if half throttle or hammer down,--- still dies.
I moved the coil out a bit thinking that was the trouble then found the gas flow was the cause.
Open to ideas here!