http://www.acehardwareoutlet.com/Produc ... =998082270
It's a 5/8" bolt hook. It was super easy to convert it into a near perfect replacement.
It's already got 5/8-11 threads, a head width that's about perfect, and has a pin pressed into it that's about 5/8".
I used a cutoff wheel to cut off the pin, then pressed it out. Then I drilled the hole out to 5/8" for the clevis pin that holds it to the dog bone.
Then I cut the threaded portion to length and cleaned up the threads.
That's it. I had about $6 in it and it bolted up perfectly.
I'm not saying it's gonna work for an original type replacement for the serious collector, but for a working tractor it's just fine.
Here's a before and a couple after pics.
Hope this helps some of you out.
