governor

[roaddenny]

lost 2 teeth on the rotor I replace the rotor and timed it per instructions i found on internet. engine started right up but runs at full throttle regard less of position of throttle lever what have i done?

[inairam]

It sounds as if the lever / spring assembly on the outside of the governor is frozen.

[k hutchins]

I had that problem years ago.
Long story short, the pin that attaches the weights to the governor shaft on the inside had worked it's way out so when the shaft turned the weights didn't, so it wouldn't balance out.
There are several threads here that can advise you on removing and reinstalling the governor.

Good luck.