Disc Harrow help.

[CDKL]

I ran across these disc harrows today, and I'm wanting to see if these are for a cub like the man says and if so what model they are and their value.




Thanks,
Chris

[CDKL]

I suppose it would help if I uploaded the pictures.

[ScottyD'sdad]

Not a cub disk, but would work.

Ed

[Eugene]

What is the asking price?

Check to see how loose the disk shaft bearings are. Is the angle adjustment crank free? Grease zerks in place and type, replaceable?

Make, model, unknown. Value, wild guess, $200- range.

Following link. Use same information when checking over this disk.

viewtopic.php?f=1&t=105716

[tmays]

Agree with both the comments above. But keep in mind you’ll have to adjust angle of disc while on the ground. That’s pretty common with a lot of them, but I’d be on the lookout for a cub 23A disc. Unless of course the ones pictured are priced too good to pass up

[CDKL]

Asking price is $100 plus 2 hours away.

[Eugene]

Price is fair. But, time and the fuel cost of a 4 hour round trip?

How wide is the disk? My guess, you will need a small trailer.

[CDKL]

Price is fair. But, time and the fuel cost of a 4 hour round trip?

How wide is the disk? My guess, you will need a small trailer.

Im not positive, I don't think the gentleman that has knows much about it either. He told it was for a cub which its not according to the previous post here.

[CDKL]

Are these the 23A? What is a fair price for the condition?

[attachment=1]938267B8-3C0C-4C96-81E2-76EC4C99757C.jpeg[/attachment

[Jim Becker]

Best I can tell, the second disk is a 23A. The first looks like it was originally a 3-point for something and it has been converted to a pull-behind.

[tmays]

Are these the 23A? What is a fair price for the condition?

C8C93747-41F7-43BF-96E3-F3414923E187.jpeg[attachment=1]938267B8-3C0C-4C96-81E2-76EC4C99757C.jpeg[/attachment

Agree with Jim, looks like a 23A. Can’t tell much from the first pic to give a value. Second pic those blades looks to be in pretty good condition, but the front ones look like serrated blades that have seen quite a bit of wear. As usual, value is determined by availability as well as condition. I consider one in good shape to be worth 250-300. I’d say 150 in the one pictured. Better pics might change my mind in either direction