Crank Pully Tool for a Cub

[hotrodcars]

Hello, I am new to the forum. I am restoring my fathers 1948 cub and I need to know where I can buy a crank pully remover/installer minus the bottle jack/ram if possible as I do not really want to make one. It's hard to find the plate steel around here. Many thanks to anyone who can help ?

[Glen]

Hi,
Welcome to the website.

Below is the Cub and LoBoy service manual, if you don't have it. It has lots of info.
There is a contents beginning on page 1 of most sections.
I would read section 1, the engine section, since you are working on the engine.

http://farmallcub.com/rudi_cub/www.clea ... index.html

[Bill V in Md]

If you cannot find the tool you are searching for, check out this How To link for another option:
http://farmallcub.com/phpBB2/viewtopic.php?f=141&t=44517&p=367969&hilit=front+pulley+removal#p367969

[Barnyard]

Hi,
Welcome to the website.

Below is the Cub and LoBoy service manual, if you don't have it. It has lots of info.
There is a contents beginning on page 1 of most sections.
I would read section 1, the engine section, since you are working on the engine.

http://farmallcub.com/rudi_cub/www.clea ... index.html

I'm not so sure the manual will tell him where to buy one

[cjack]

My son used this setup. Monster puller and a bearing separator. I don't know where you can find a puller like that- we borrowed it from a friend. We used heat on the pulley and an impact driver on the puller to get it off.

[Glen]

Hi,
When using a puller with the long threaded rod, I like to put oil on the threads, and work oil into the threaded part the rod goes through.
It helps a little to reduce the friction there when you are pulling hard with the puller.

[hotrodcars]

Hey folks just wanted to say thank you all for the help, I got it off and now I can take the engine out for over haul !!! Thanks to all !!!!!!