zoning

Mr Joshua

Well-known member
I would like to in the near future build me a new home for my tractors. I called the zoning office today and found that i can only build up to a 960 square foot building which is very disappointing. they also said that the set back is 50 in the rear and 10 on the side. Does anyone know how to measure that? I live in jefferson county MO 63023.
thanks
Josh
 
Mr Joshua":15fo75kt said:
I would like to in the near future build me a new home for my tractors. I called the zoning office today and found that i can only build up to a 960 square foot building which is very disappointing. they also said that the set back is 50 in the rear and 10 on the side. Does anyone know how to measure that? I live in jefferson county MO 63023.
thanks
Josh
You can measure it with a tape measure. Just measure 50 feet from your back property line and 10 feet from your side property line.
 
Barnyard":29ewhhp3 said:
Mr Joshua":29ewhhp3 said:
I would like to in the near future build me a new home for my tractors. I called the zoning office today and found that i can only build up to a 960 square foot building which is very disappointing. they also said that the set back is 50 in the rear and 10 on the side. Does anyone know how to measure that? I live in jefferson county MO 63023.
thanks
Josh
You can measure it with a tape measure. Just measure 50 feet from your back property line and 10 feet from your side property line.
thanks barnyard
just was not sure if they meant like 50 from the back of the building or what.
 
Josh,in other words, the back of your new building has to be 50 feet from the back line and the side of the building has to be 10 feet from the side line. Depending on your lot size you may also have to be a set distance from any other building on your lot.
 
960 sq ft will give you a building that is roughly 31' x 31'. If you want a larger one, you could see if there is an appeal process or way to request a variance. You would probably have to have your neighbors okay and some justification for the larger building. Some of that will depend on the type of neighborhood you are in, your lot size, the neighbors lots, etc.

Bob
 
Josh:

Up here for those who want to design/build themselvesbut do not have the experience, there are qualified draftsmen who provide design services and should be fully conversant with your local zoning requirements and what is needed for a variance. Suggest you seek one of these out and have them give you a hand. You may have to provide a current plot/site plan but that should be in with your deed. You should probably be able to find a draftsman in your yellow pages.
 
Man, I am glad I live in the country.

I would not know that I cannot do this or that and get in trouble.

Not being use to having to ask for permission, or being told the way I would have to do things well.....I am sure they would have a way $$$$ :oops: :evil: of getting my attention.
 
Tezell":i0qnb36o said:
Man, I am glad I live in the country.

I would not know that I cannot do this or that and get in trouble.

Not being use to having to ask for permission, or being told the way I would have to do things well.....I am sure they would have a way $$$$ :oops: :evil: of getting my attention.
Even in the country in Ohio there are zoning limitations for some things in some areas. I find that some of those are good things even though it limits what I can do. The township next to us has no zoning what so ever and you can put up any size building you want, but your neighbor can have a garbage dump right up to your property line.
 
I am a firm believer in my land is my land, and I am blessed with being able to do with it as I see fit where I live.
If my neighbor was paying the taxes on it I would give him a say:D Too much government in my opinion.
Boss
 
Josh was only asking about where to measure so he would be in conformance with his local regulations. Idon't think he intended this to be any type of political debate and I hope it doesn't go there.
 
Josh.

Visit you local zoning office. Obtain a copy of your local zoning regulations. Take the copy home and carefully read. Then go back and ask questions.

Questions to ask upon your return visit is: "are there other county, regional, state or federal laws concerning my potential building?" "Do I need a building permit?" Problem is that the local zoning commission is not going to know all of the laws that affect new construction.

It may be worth a bit of money to obtain legal advice.

Edit: Nothing worse than finding out that you newly built building doesn't meet some code. You have to tear it down and perhaps face a huge fine.
 
To get back on topic:
First off, if the limit is 960, I'd be looking at 24x40 not 31x31.
Are you in an unincorporated area of the county or in an incorporated village/town/city? I took a look at the county zoning regulations, which apply if you are in an unincorporated area. I find a table that lists setbacks with at least one district that gives side setbacks of 10 and rear setbacks of 50 FOR THE PRIMARY STRUCTURE. I presume this is the source of the numbers from the zoning office. Of interest is section 400.2770 C. Standards For Accessory Buildings In Residential Zoning Districts. Among the standards:

. . . shall be placed in the rear yard, except that a detached garage may be located in the side yard . . .
The minimum required side setback for the principal building shall be observed for accessory buildings.

However, it does NOT state any requirement for a rear setback of an accessory building. If it had been intended that the rear setback be the same as for the principal building, they would have stated it the same as they did for the side setback. It does not make sense for the rear setback of an accessory building, located in the rear yard, to be the same as the setback for the primary building. If that was the intention, it was accidentally left out of the ordinance. I imagine you want some rear setback. But if 50 feet is a problem, I would ignore the 50 feet and apply for a building permit (I assume a permit is required). If the permit is denied due to the 50 feet, appeal it to the Board of Adjustments. Before going to the B of A, I would probably have an informal conversation with someone of higher authority than the zoning office. (In Texas, the step after the B or A would be District Court, where you would clearly win. But it could start to get more expensive)

http://z2codes.sullivanpublications.com/sullivan/Z2Browser2.html?showset=jeffersoncountyset
Click on TITLE IV then Chapter 400.
 
Yes get a copy of the zoning regulations. Regulations can vary from county to county even in different fire districts. What is OK here might not be OK across the road.
 
Josh:

Visit your County Assessor's office. The Assessor will/should have a description (mechanical drawing) of your land/plot and perhaps aerial photos.

In Iowa the County Assessor has aerial photos of your property and adjacent properties. On the aerial photo the property lines have been added. The aerial photo is a great tool for building planning projects.
 
thanks for all the replys. what i would really like is a 36 x 50 building. I have walked and area out and have found thats what i can put up and still have some space around it. the only thing that really confuses me is that i want to put the back of the building facing the side if the property. I am wondering if i can get away with the 10' considering thats the side of the property. if thats the case all i would have to do is get the code of the 960' appealed.
I already have a 24 X 24 on the property but its just not big enough. We have amanda's elcamino in there, 51 super a that in restoring, 55 cub, 49 cub, 48' C and Amanda's Zero and lots of other things. I really would like to be able to put my truck and the 45 A inside as well as move my 74 super beetle from my dad's.
I guess now i need to see how i can get some more cash and to look into zoning more.

I do not live directly in a city area but I am close to a highway and the area where i want the building can be seen. If the area was more hidden the building would be up and complete before anyone ever knew it.
Josh
 
Mr Joshua":2ip4mmr4 said:
i want to put the back of the building facing the side if the property. I am wondering if i can get away with the 10' considering thats the side of the property.
Josh, it won't matter if it is the side or the back of your building. The ten foot off set is for the side of your lot not the side of your building. The main thing to remember is you have to be ten feet from your side property line and fifty feet from your back property line. Keep in mind also that some codes have restrictions on where the doors face. Some say they have to face the street while others may not have a requirement. The size of the lot has a lot to do with that determination.
 
When living in an area with restrictions, such as Jefferson County, it is not a good idea to try to sneak a building by without the permits. Many of them are now using Google earth to verify what is on the property for tax purposes, and when caught the penalties and fines, including possibly having to remove the building, concrete,etc. can be pretty stiff. In the rural areas such as where I live the pictures frequently are only updated every 4 or 5 years. As you get closer to major cities though the updates become more frequent, sometimes every month or so.
 
I had a survey of the property taken last year. I guess i will take it to an architect that i know and see if he know things that i don't. possibly then we can draw up a plan to take to the county. If we would have picked a house about 5 miles south we would be in a different county and thing would be much better.
 
Back
Top