wiring a key start switch

brichter

501 Club
On my Allis Chalmers B I have a starting problem. The twist type starter switch seems to be messed up so I wanted to replace it with a key start switch. Now the tractor is a 1939 with a magneto. Someone in the past installed a starter with a solenoid, added an alternator to charge the battery, and changed the battery to negative ground. I need some guidance as to how to wire up the new key start switch. It has a lug labeled BAT, one labeled IGN, one labeled ACC, and then has one in the center which is unlabeled. Any help would be greatly appreciated.

Billy Ray
 
Multi-meter set on Ohms. Pencil and paper, marks/letters, indicating each terminal. Start with the key in the off position. Go from terminal to terminal. On the paper draw a line from connected terminal to connected terminal(s).

Same thing with the pencil and paper. Ignition key in next positon. Etc.

4 terminals, 4 wiring diagrams. This should tell you how the switch works and perhaps how to wire it up.

Question. Does the switch have a provision to kill the magneto when you turn the switch off?

Edit: Did the old switch have marks/stamped letters on the terminal? If so, did you label each wire as you removed it?

Another edit: NAPA or Federated auto parts, part number 7-01852, magneto ignition starter switch. Switch has provisions for and marked for: Lite, Bat, Grd, Mag, Sol.. It's a 4 position switch, 3/4" mounting stem, 5 screw terminal.
 
Just converted mine to 12V recently and put in a key switch and solenoid....the 3 key posts on the key switch are connected as follows: BAT goes to the ammeter, the IGN goes to the coil and the SOL goes to the solenoid.
 
Eugene, I have a magneto but the previous owner added a starter, solenoid, alternator, and a funky twist style switch to start it. the starter switch has gone bad and when I went to replace it thete was 6 lugs, none labeled, some just taped up and others connected but there was no way to identify the connections. I just went to the parts store and bought a universal ignition switch.
 
Billy Ray. I don't think the universal switch will work for your application unless it has a provision to shut off the magneto. You can Ohm out the universal switch, earlier provided instructions, to see if it will work.

The part number provided earlier, I used on a Case 1816 skid steer with magneto. I used the Lit terminal to power the electric fuel pump. The one terminal on that switch, you may or not need is the Lit (lights).
 
Billy Ray, I would assume that the center post would be the starter. If you are only using the switch to start the tractor all you need to do is run a hot wire to the bat. post and run from the center to the solenoid. If the solenoid has only one small post that's were you run the wire, if there are 2 small posts 1 is a ground for the solenoid. If the switch is used to shut the tractor off then as Eugene said you will need the right kind of switch. (one that grounds the ign. in the off position. I think most mag. fired lawn tractors have this type of switch.)
 
Back
Top