What the heck!

Barnyard

Moderator
Staff member
What is wrong with this picture?
headscratch.gif


plowdemo.JPG
 
I was hoping those who know wouldn't give it away too fast for those who weren't there. :lol:
 
The only thing I see wrong is the JD sticker is above the IH sticker. :lol:
Tilted to the right gives you a better oil drain when you pull the plug. :lol:
That is a very nice looking tractor also.
:thumbsup:
 
RAS51Cub":2nmjx129 said:
The only thing I see wrong is the JD sticker is above the IH sticker. :lol: :lol: :lol:
And we all wondered how that sticker got up there too. :lol:
 
Well I see another IH sticker above the running deer (behind the lantern) so I'd say he was surrounded.
I assume that you were combining the plow set up demonstration and the tractor splitting and rejoining demonstration into one presentation to have the ramps facing opposite directions.
 
I vote the obvious. You can't drive a tractor on those ramps, but you can hoist it there. And it would be one heck of a thump driving it off!!!!
Now that might be set up for a demonstration of "How not to split a cub."
 
The chain host hanging there is pretty much of a giveaway, but my first thought was why, till I noticed the plow, and then I ASSumed it was to demonstrate how the depth control on a plow worked to create suction and control the plow depth, or else how to adjust the concentric bolts on the beam to set it level in the furrow.
 
The obvious answer are the blocks facing opposite directions (of course those green stickers make for another). When I first saw it from inside the shop I had to get a closer look. Of course after talking with Bigdog and Denny I decided photo was needed. I did a little cropping of the original photo to remove the bottom portion of the shop crane or there would have been another "What's wrong with this picture" to contend with. :lol:
 
John *.?-!.* cub owner":3ddmnu1s said:
The chain host hanging there is pretty much of a giveaway, but my first thought was why, till I noticed the plow, and then I ASSumed it was to demonstrate how the depth control on a plow worked to create suction and control the plow depth, or else how to adjust the concentric bolts on the beam to set it level in the furrow.
You're on the right track there, John. That was about the time Bill Hudson said during his demonstration, "I'm sure you've all heard it said, THAT SUCKS! :shock: Well, that's what the plow should do." :)
 
Back
Top