Wet sand blasting

moparado

Well-known member
While looking for my chainsaw owner's manual, i ran across my pressure washer's manual and noticed there was a sand blasting option for it. Its around $70.
For large workpieces that won't fit into my blast cabinets, i've been dry blasting them outside and the sand gets into everything requiring an immediate shower and change of clothes. Wearing a zoot suit is out of the question! :roll:
I'm thinking wet sand blasting might be less messier as i don't seem to get wet at all when pressure washing.

Anyone have any experience with this pressure washer option or wet sand blasting in general?
-Ken
 
I have never used one myself, but the most common comment I here is that the nozzles are pretty short lived.

when sandblasting out side, I wear a hood over one of the $6.95 Ponchos form the Walmart sporting goods department. really helps.
 
I have had a Northern tool wet sandblaster for 3 yrs. Done at least 3 tractors plus numerous other things. Same nozzle. 2800p.s.i. machine. You can blast without a hood, there is very little blowback. But I would recommend eye protection. I use a product called black beauty, which says on the bag its a slag product? Little issues with grit sticking to piece blasted but I rinse it right off with a hose. To prevent rust spray immediately with WD 40. Word of caution- You must keep the nozzle pointed down from level. otherwise water will run back up the sand hose, and wet the grit,in the supply hose, then your out of business. Oh- I forgot to mention---- YOUR GOING TO GET WET. Frank
 
I would imagine that it depends on the part you are cleaning as to how wet you are going to get. I power washed a front rim for a friend and I'm glad I changed into some old clothes. There wasn't a dry spot on me when I was done. :lol: :lol:
 
There wasn't a dry spot on me when I was done.

H'mm, i must be doing something wrong. :?
I recently pressure washed my Cadet specifically to get 20 years of an inch thick layer of gunk off the tranny area before changing the fluid and filter. Hardly got wet at all. I used the hi-PSI nozzle which i could be wrong here but i believe uses less water flow than the standard nozzle. I also stand as far back from the object as possible with the nozzle gun arm outstretched.
I did get hit with a couple liberated chunks of gunk though! Maybe those gunk chunks liked it where they were? :lol:

Maybe the length of the nozzle wand, flow rate of the pressure washer, type of nozzle used and the angle the water stream hits the object makes a difference...i don't know. My washer is a cheapie rated at 1800 PSI with under a couple gal/min flow rate. My old shallow well can't support a better washer. :(
-Ken
 
The rounded surfaces are what got me. I have since learned not to point the spray directly at the rounded surface so that way it doesn't splash back so much.

Experience I guess is a good teacher. :lol: :lol:
 
Back
Top