Well Pumps

BigBill

501 Club
I just moved off the main water supply grid and i'm getting everything thrown at me that could possibly be thrown. No kictchen sink yet but close.

When i first moved into the new to me place(built 1957) the water pump would constantly run for a longtime to build up pressure. I ordered a new pressure switch but found out the tubing that supplies the water pressure from the pump housing to the switch was plugged up. I installed the new switch and cleaned out all the fittings and tubing and fixed that problem. Now about 1 1/2 years later, lastnite at 10:30pm the well pump was moaning trying to start with no success. The wife called a local 24hr well service guy at 11:00pm and we didn't get a return call till after 9am. So much for the 24hr service? I canceled him after he told me i had to wait another 2 hours. We shut down the furnance lastnite because of the hot water heat and the hot water supply from the boiler i didn't want to have to replace the furnance too. Thank god i have the woodstove cooking and we have plenty of heat and firewood. I found out without the furnance running at all i have the house at 63 degrees with just the woodstove.
Now we called all over the place to find a new well pump with no success. With any place i would have to order it. So i figured thats 2 or 3 or more days with water. I got upset and ripped out the old well pump and took it apart. I found it caked up with rust when i removed the pump housing. I then attached the wires to the motor and it ran. The rust actually jammed up the pump. Well it will run now till the new pump i just ordered will be here. Once the smoke clears i'll order a backup new pump too just incase. :{_}:

One other thing is i always keep some silicone on hand for just problems like this when you don't have any gaskets. Even the clear silicone will work too but i stock the clear and the high heat black silicone too just incase we have a break down when the stores are all closed.

I feel like a fireman again going from fire to fire but i'm not even working on my tractors. I just started working inside the house on friday fixing broken things and next i have two bathrooms to remodel too. With the cold outside i figure to get my honey do list somewhat done. I couldn't catch a break in 2008 and in 2009 it appears to be the sameway....ditto.. :)):
 
Bill - when we were on our own well it seemed it would always be the most inopportune time when it failed. I do not miss messing around down in that well pit. Especially in the winter.
 
Bill
I am with you on the well ordeal , we have recently been thru the "24 hour well hell" . It sure pays to keep some parts on hand for these cases , but that doesnt remove the frustration of dealing with the darn thing at odd hours in cold temps and while momma is waiting to get back in the shower so she can finish. :wink:
 
hey Big Bill,

you know what, we have a 60 footer mobile home sitting in the country, about 2 years ago, nobody was out there, of course all the pipes busted including the toilet bowl. You can imagine the mess. The first thing I did was replacing the copper pipes, cause in situations like the they are no good, they burst were you can't reach them and that's the floor. Replaced them with white plastic pipe, and no joints in the floor, straight from one end to the other. Those pipes won't crack if the are frozen.
Now coming to your well, is it drilled or a dug well, big difference. Our drilled well, a 6 inch pipe is 250 feet down because of bedrock, but the guy hit a stream, water comes up like crazy. Once we had minus 38 Celsius, the water was there about 5 feet below ground and not frozen. The other thing I have is the supply pipe from the well to the house, same material, does not crack or burst, but it freezes, to bypass this, I have a heating cable wound around the pipe, no problem.
As for you pump, you need an encased one, of course she costs a bit, the one I have is in the well for the last 20 years, still runs. You also have to take into account how you water is, lots of iron, sand ?
I know for a fact, the guy you call for help shows up when you had it fixed yourself, and who needs that.

Sorry Bill, my story wont help you much, just . . .
 
Bill,

Sounds to me like you have a jet pump. Have you considered replacing it with a submersible? Much more efficient.
 
I hate that you are having troubles with your well. We always had a well when I was growing up and we had submersible pumps too. Never really had a lot of problems with them. We did once leave the water hose on while playing with a slip-n-slide, :-:-): we brought out some sand from that well. oops. yeah, we got a good whippin for that trick. You keep chiseling away at that honey do list :||): and when the weather clears you will be clear for the outdoor fun tractor stuff.
 
big bill hang in there with that pump. i've had to deal with similar stuff this year, after the summer before while digging the footer for a set of steps going to the rear of the house my hoe operator snagged the water line. i've been here 28 yrs and never really had a lot of problems , but snagging that line snatched the well pump into the wall in the basement, breaking the end off where the water line entered the house. went to tsc grabbed a new pump and got it installed that day. it never was quite right,coming off and on and what not. i have a hand dug well 30' to the water. after the repair last winter when we got heavy frost but no snow the line coming in froze up. i had to use a torch to thaw the ground where i knew that the line was to close to the surface. after getting it thawed out and dug up, i caught pure :censored: getting the well to prime and pumping. i knew that my temporary fix was just that a temp fix . thought i would be smart and go on ebay and buy a submersible pump,which i did and i engineered a plan to install this pump.then i realized i had bought a three wire pump instead of a two wire and needed to get a starter box. got that on ebay also. had my cousin kenny come over right before it started to freeze around here and dug up the water line from the house to the well, only 10' but rough digging. i have a concrete core saw here but didn't have a 7" bit, rental place didn't have one so i lucked up with a local electrical contractor that i have worked with and he fixed me up with the six inch pipe and the core bit i needed. after fabricating the pipe with a pitless adapter and cutting the bell off and refitting it so the pipe wouldn't fall down into the well,i went about installing the new 4 wire cable from the well to the basement . i have a craw space under kitchen and was talking kenny into going under there to get this wire in. we were all setup to go when kenny noticed that a corn snake had got up under there. well that just ruined him. i killed the snake and took it up to the shop and showed him it wasn't poisoness. it didn't make any difference because his nerves were shot because he couldn't get over the idea of if he had climbed down in there and then discovered the snake. :roll: :wink: anyway a few days later my buddy anthony came over and said for a fee he would go down there.we got the wire ran and i went about mounting the control box and rewiring the power source to 220vac. after that i removed the old pump and installed all 1" pipe from the wall to the tank ,installing the new high low shut off switch and also a whole house filter from tsc,culligan. after all that was in place i went back out out to the well ,checked my measurements for probably the 100th time and went about setting the well pump and putting it in service.i only had to make a few adjustments to the fittings tightening this and that and as for now it's still pumping. i need to figure out why it pumps off and on instead of building up a pressure steadily and just holding that. i just posted this, just so you know that it could be a lot worse then it is.
 
Bill: I experienced an eerielly similar event at my SILs home in Maine 2 yrs. ago. He paniced, went out and bought a new pump. I took everything apart and cleaned the rust deposit caked inside the pump housing and all the metal fittings. The galvy fitings plugged up the worst, followed less severely by the brass ones. I noticed the white PVC and black plastic attracted almost no corrosion. Everything possible NOT made of plastic came out replaced by plastic fittings. I set up the repaired old pump exactly like the new one with Unions, so he could change pumps quickly should the pump plug up again. 2 years and still going strong. Make sure you put a shut-off or check valve before the pump so you will not lose the prime if you have to break a joint.
 
The submersables are all they sell around here!---and I despise them!!--pump man said IF we are lucky this new one will last 5 years---not lucky?--then 2 years!--the old "working head" jobber lasted over 40 years and was never touched , but when it went, the whole thing just fell apart!--pipes ,cylinder, and linkage,--so after figuring repair cost the new sub. system was quicker to put in and about half the cost,--but not reliable! (it was -10* that day!)
If the well was not 164 feet I would go with the jet system!---still cant beat the ole working head style ! just my opinion and hands on knowledge of well pumps! thanks; sonny
 
Ok she pumps water now but i can't get more than 30lbs. pressure. If i pull apart the relay to stop it the system holds at 30lbs steady. I'm not familair water pumps but mainly with hydraulics and there is a screw adjustment which i think is a pressure adjustment. I'm going to play with that in the morning. Its still a learning process too.
 
Some switches have 2 set screws, 1 for the start pressure and another for the differential (the span) pressure. The information is usually attached to the inside of the switch cover.
 
yup cut out, and cut in, high and low pressure, after looking at this post and replying i went and looked at the set up again and do believe i'll be needing a new holding tank. it's weeping from somewhere underneath. oh well just another on the to do list. :)): :arrow: :idea:
 
Ok not having really good water supply since saturdaynite, since my pump isn't reaching the 50lbs pressure it needs to have we called a local supply house for a pump. The salesman says they don't sell to the public but he has a good guy who's honest and does good work that i could call. "Well" while thinking about this my well pump motor died again. So i broke down and called the man. With my health and the pump is where i can't really get to it i had to. My son helped me yesterday as much as he could. I have a hard time walking in homedepot(stores) now too.

My only problem is why i been holding off doing this is i heard the town wants everyone to use the submersed well pumps but i've read that they don't last so long. I did talk with one water guy who says its a $2,500 bill to do the change over. My jet pump just lasted for 32 years in the house so why change? I hope this guy will just change out my pump only. Its not the $$ envoled its the life of the outside pump. A new inside jet pump should outlast my lifetime i'm sure.

All this time i could of been working on my tractors.
 
I dont know if this is common or a fluke event. The same SIL , at a different house spent a few thousand to put in a rather deep well. He put a submersible in the casing and thought his troubles were over. Until a freak bolt of lightning hit the casing and "welded" the pump to the casing, 100 ft. down. Cost a thousand or so more to remove the casing and the pump head, and start over again.
 
I had my fill of jet pump issues, about 15 yrs. ago. It seemed that every time I turned around there was problems with the system. I finally bought a submersible pump & had my plumber buddy help with the install. I haven't had a pump issue since. I also like the fact that I don't have to listen to it. I know that some of you have issues with submersibles, I'm guessing that it probably has to do with the content of the water. While my plumber buddy still works on jets, occasionally, neither of my well friends will mess with them. In this area, a jet pump is a dinosaur.
 
Oddly enough the foot valve in my well shot crapps last night just a little after dark.

Had to hang a ladder down in it, climb down unscrew the pipe pull it out to check the size.

Called my Brother, had him pick a new foot valve up from the local (as local as it gets around here) farm store on his way home, put the new one on, shook the pipe up and down a few times to fill it with water, screwed it back together, plugged the pump in and it took right off, didn't even have to prime it.

All in all it went very well (no punn intended) except waiting on the part, only took about an hours worth of actual work, one of the perks of having a hand dug well it's easy enough to get down inside of it.

We had a little ice storm and quite a bit of rain just before Christmas, ever since then the water has been a little dirty. I was really surprised to see the water level so high when I pulled the cover off last night, it was less than 5 ft. from the top, got my boots a little wet standing on the ladder and I had to crouch way down to reach the pipe to unscrew it where it comes into the side of the well from the basement.

My Grandfather dug the well in the mid-late 40's, they only had a hand pump until 1955 then they put in the electric pump and plumbed the house. Still using the same pump and tank today... It's a Jacuzzi Brothers inc. pump and tank. Sure has been a good one, I would really be pleased if it would last the rest of my time. I also hope I get a Grandson some day, by the time this valve goes bad I should be way too old to be climbing down in there to replace it.
 
Heller, one thing to remember, and think about with the hopes of a grandson is that if your water gets dirty or cloudy when it rains, ground water is seeping in and bringing lots of contaminants with it, probably some fecal matter too. You have lived there all your life and probably built up a resistance to the local soil bacteria, etc. he may not e so fortunate. There is a reason that wells are now required to be cased 80 feet or more. One other thing, a licensed well or pump man will not touch your well.
 
Back
Top