watizit?

ljwfarming

501 Club
Maybe you guys can help find out what this item is. I found it in a boxlot purchased at an auction a few months ago. It looks like a hammer, but I don't know. It could be a latch or an opener?
Larry
290336430.jpg
[/img]
 
Guys, thanks for all the knowledge, experience, pragmatism, put into your replies! :) In addition to a metric conversion lesson. :roll:

You know, there's a writers strike going on right now. And I'd bet a lot of you guys could pick up some loose change by filling in for them. :P I'm thinking Johnny Carson, et al......wait a minute I think he got cancelled! :(
I had some of the brightest minds in Butler County, OH working on this with no results. But I knew that this collective group of savvy individuals could sift through the BS and come out clean! :lol:

Seriously, I think that a stove lid handle may be really close to the right answer.

Rather than sell it, which I realize everyone wants to buy it; I think I'll take it with me bar hopping and use it as a conversation piece to pick up chicks. 8)

Thanks for the input, Larry
 
Would that tip end fit in the holes of metal tops of 5 gallon cans? If so it would open and close them. As for gallon cans most of the openers I know of have a bend or sweep.
 
Rick wrote:
My guess would be a paint can opener/closer for the pint/quart/gallon cans.

Rick and John may have the best ideas. I looked at it closer this AM and I noticed at the base of the handle that it's formed slightly like a prybar. As in prying open paint cans. It's shaped like a flat finger tip. Could the little appendage on the claw part of the hammer be used for cleaning the drip edge? And the hammer used for fastening the lid? There's some writing embossed on the handle, but I can't read it.
I should have listened to more input before being too anxious to make a smart-alecky reply. :oops:

Larry
 
Larry, my thoughts were the
Could the little appendage
fit under the lid lip and pry it open? then pound it shut with the hammer. Just seems if the whole thing looks like maybe 4-1/2" long, you better wear gloves by a stove :shock: that's awful short.

Rick
 
ljw":1hgnjrgn said:
I had some of the brightest minds in Butler County, OH working on this with no results.
They must have been visiting from Hamilton County. :lol: :lol: Just kidding with ya' Larry.

ljw also":1hgnjrgn said:
I think I'll take it with me bar hopping and use it as a conversation piece to pick up chicks. 8)
:shock: :shock: :shock: No comment!
 
Back
Top