watersteps
Active member
Anyone have a outlet gasket handy? I don't have an old one to measure, I need the 3/8th bolt holes center to center and large hole diameter. I think the large hole is about 1 5/8".
Water outlet gasket dimensions.
- Thread starter watersteps
- Start date
Don McCombs
501 Club
If you have the outlet casting, you already have a pattern.
staninlowerAL
501 Club
And with a small ball peen hammer you can easily produce a gasket! Brass spent shell casing makes a good hole punch also. JMHO Stan
watersteps
Active member
The outlet is mounted on the engine and the radiator and engine are full of anti-freeze. I know how to make the gasket, I just wanted the dimensions to make up a few gaskets for a project, and I did not want to buy one and wait for it top get here.
Mike in Louisiana
501 Club
T M tractor has them. Not expensive at all.
watersteps
Active member
Thank you, I just want the dimensions.
Bill V in Md
501 Club
I have some gaskets left over from an engine rebuild over twenty years age. I believe the one in the photo is for the water outlet elbow, but no way to be certain, as the dimensions shown do not match your guesstimates. The two small holes are closer to 13/32" dia (0.40"). That being said, I have no need for it, and can mail it to you, if you like. Just send me a direct message with your mailing address.
Attachments
watersteps
Active member
Thank you very much, but I don't really need it since you gave me the sizes I do need. I am making a spacer that will mount under the water outlet casting that will hold a temperature sending unit. I will use these sizes to make the steel spacer. Then I will make a few gaskets to seal the spacer. Thank you again this really helps. And thanks for the offer.