water hammer

john2189

501 Club
Lately Ive noticed my pipes hammering when the clothes washer gets full of water and shuts the valve. It has never done that before. Nothing has been done to the pipes or well. The water pump does not seem to be water logged, it seems to work as normal, good pressure etc. I dont see any pipe hangers loose. What could be causing this ? I think I can buy a thing to put on the water hose to stop this, but that doent fix whats wrong... It hasnt done this for the 30 years ive been living here.

John
 
John:

How To Stop Water Hammer

If you never had hammering and then it suddenly starts, most likely your plumbing system's air chambers have become waterlogged. You can cure water hammer by turning off the water behind the waterlogged chamber, opening the offending faucet and permitting the faucet to drain thoroughly. Once all the water drains from the chamber, air will fill it again and restore the cushion. If the air chamber is located below the outlet, you may have to drain the main supply lines to allow the chamber to fill with air again.
 
Plumbing code in my part of the country states that anything with a "quick closing solinoid" must have a "hammer arrestor" installed on it. Ex; dishwasher or washing machine. Sevral things could be causing your problem. There will be no ill affect on your plumbing sysytem as long as you get the hammer arrestors installed. VERY simple to do and any Lowe's or Home Depot will have them. Only in severe hammering will plumbing actually be harmed. It's more of a nusience than anything. Most likely "something" has changed in your appliance rather than in your plumbing system. I'm a plumber and not a appliance repairman so I won't even try to diagnose you washer. I'd just put the hammer arrestors on and forget about it. :)
 
I'm no plumber and won't claim to be one, however I have experienced water hammer arrestors which have lost the air in them, thus the "cushion" to prevent the water hammer effect. Replaced the unit(s) and all was well.
 
Deduced from the original post, this is a rural water system.

The top half of the water storage tank should be an air bladder used to maintain water pressure when the pump is not operating. Guessing the air bladder has lost air pressure.

Our rural water system use to loose air pressure. It had a schrader valve on top of the tank. Ever so often we would have to use the air compressor and pump up the pressure inside the bladder to 35 or 40 psi.

Son is hooked to a city type water system. Similiar problem. I think the air bladder/tank cost him around $35- to solve the problem.
 
Don't mess with the expansion tank on the well system unless you know something about them. The proper way to add air to one is to bleed ALL water pressure off of system, simple as killing power to pump and turning on a faucet. Then check the air pressure on tank. The air in the tank needs to be 2 to 3 psi LESS than the CUT IN PRESSUE on the pressure switch. Ex; if your switch is a 30-50 switch you need 27-28psi of air in the tank. To much air, usually way to much air, and you'll bust the diaphram. If tank has to be pumped up every so often change it. A good tank will not loose air, guarentee it. Good luck and like i said, get the arrestors and forget about it IF tank is in fact good. A simple solution for a complicated problem.
 
Is this a new issue ?
If not check a shutoff valve for a loose screw that holds the rubber washer on.
this might be the problem if you did not have this issue before
 
Back
Top