Wanted. Ford Mecahnic, Heater Problem

Eugene

501 Club
Heater problem, 1993 Ford F250, gasoline engine. Heater core hot, vacuum motors working. Cable controls working. Tepid to no heat on heat side of control (defrost, mix & floor). Great heat from dash outlets when heat control set on vent.

Questions. Is there an easy way to get to the blend control door without removing the entire dash and under dash wires and controls? Is there something else to check before I start ripping out the dash?
 
Carl. I'll take a look and see if this set up is the same. I have a Chilton with no information on the topic and searched the internet. Really need the defroster working at this time of year. Thanks. Eugene
 
I bet something has dropped down the defroster duck cause I have had it to happen :D keeps the door from opening or closing
 
I had a similar problem and it turned out to be a check valve in the vacuum line. It was under the dash and if I remember behind the glove box. Had to take the box out to get at it. It was round about 1/2 inch in diameter with the slip hose fitting on each end.
 
Thanks for the replies.

I'll drive the Dodge pickup until it warms up a bit. Need to do some more investigating. I did find a broken vacuum line - repaired but still not solved the problem.

Dash controls move the lever that is supposed to operate the blend door. So ???
 
Can you hear the door open and close? It should make a thud noise at both maximum heat and cold limits. It's likely the door has broken off. Or some Mouseketeers found a new home.
 
Making some progress. Located the vacuum motor controlling the door. Vacuum motor works but doesn't change air temperature. No sound accompanying the vacuum motor lever movement.
 
Another item to check is the vacuum motor output shaft. It should be shaped like a D. If the corners of the D break off, the motor still operates but can not open or close the door. There is a DIY fix for that problem as well.
 
Back
Top