Truck won't start

Jeff Silvey

501 Club
I went out to go to an meeting tonight guest what didn't happen :cry: . My truck won't start. I pulled a spark plug. It had an yellow spark. Eveything turns over, hear the fuel pump pumping no fire. Do I have a real weak coil. My truck is a 1996 with 136000 miles. Just need some help I think. I haven't changed anything sense I have had it.
Jeff
 
Buy/borrow a code reader and see what code numbers it throws out ! Craig
 
On my car - SAAB - you just plug it in and turn the ignition on. It's not supposed to be running in my case. Craig
 
I bought one for my old bronco (which still isnt running :evil: ). It detected codes while the bronco was off. we've also used this computer on my uncles F100 while it was running. With ours at least, we can use it to detect problems running or not-depends on the case. Cant speak for all of them though. good luck with that!
 
Just a little update. Had truck towed to a repair shop. I sprayed starting fluid in carb. It tried to start. I did change the fuel filter. The guy at the auto parts store said its the fuel pump. I think he's right. Plugs,cap,rotor,& module did hurt to change. Nice blue spark.
Thanks for your ideas.
Jeff
 
The hand held "Brainmaster by Alltest" that was used in the shop where I used to work would get the codes even if it would not run.
Codes are broken into 2 catagories- Hard & Soft. Usually the fist code given can trigger the rest of the codes if others are given.
Fix the first code first :!: :!: :!:
Disconnect battery 30sec-1min. to clear the other codes.
Try to start it, hopefully all is good. If not the other codes will appear (maybe not all of them), fix the next code in order given.
Clear the processor memory again & try to start it up. In the event it starts up, you will need to read the codes again to see if the is more stored after a test drive.

You will also need the code book to follow the diagnos tree given and in most cases all you will need is a digital volt ohm meter to do this.

The Code reader & book is expensive as well as keeping it updated for the next year models by replacing the chip or at least that was in the later 80's.

Some shops will read the codes and give them to you at a modest but fair price because it only takes a couple minutes to do this even in a white tux.
 
Back
Top