Truck & Car Ramps

Hey Guys
I'm in need of some ideas on building a good set of truck ramps for changing oil & other work under a truck
i have had two sets of ramps and low and behold they do bend very unsafe and the plastic ones don't get it up high enough for a fat boy like me on a creeper to move around and not get stuck
so if anyone has built a set and would post pictures and measurements i sure would apprecitate it

also don;t want to make them out of wood i'm thinking angle iron or square tubing

thanks
48 Barney :big afro:
 
I use a floor jack and jack stands.

I have a set of ramps. But found they slid forward as I was trying to drive the vehicle on them. Or, the vehicle bumber would hit the stands before the wheels.
 
Eugene":1mmmf06k said:
I have a set of ramps. But found they slid forward as I was trying to drive the vehicle on them. Or, the vehicle bumper would hit the stands before the wheels.

I had the same trouble and found if I put a piece of plywood about a foot wide and 18" or so long under just under the leading edge of each ramp they won't slide anymore. I put a couple of the plywood inches under the ramp and leave the rest out front of the ramp. Once your tire gets on the plywood, it's then held in place and as the tire starts up the ramp it makes the ramp bite into the plywood keeping it from sliding. If my bumper hits the ramp, (and my wife's car does) I lay a 2x4 or 2x6 about a foot long lengthwise in front of each ramp. As the front tires ride up on the boards, the bumper will raise enough to clear the ramps and then I drive right up. When backing off the ramps, just make sure that you back down slowly so the suspension doesn't compress as the car comes off the ramps, which can make the bumper hit the ramp. With my truck, I just use the the plywood. Never have had the ramps slide since.
 
Eugene":32tajo31 said:
...
I have a set of ramps. But found they slid forward as I was trying to drive the vehicle on them. Or, the vehicle bumber would hit the stands before the wheels.

Had the same trouble until I drilled holes in the concrete floor and then simply dropped a 1/2 bolt through an existing hole, in the leading end of the ramps, and into the drilled concrete. Worked like a champ and no need to figure out where to put the ramp each time. Store the bolts in the floor to minimize 'stuff' getting in the holes.

Bill
 
Eugene":18xa2gj7 said:
I use a floor jack and jack stands.

I have a set of ramps. But found they slid forward as I was trying to drive the vehicle on them. Or, the vehicle bumber would hit the stands before the wheels.
My experience as well. Have tried the same fixes Ricky uses. Less trouble to just go with the floor jack and jack stands. I gave away one pair of ramps I never used. Use another pair to collect dust. Sometimes it is useful to jack the car up with the floor jack then stick the ramps under the wheels.

I have a pair of wooden blocks made up of cribbed 2x4s nailed together. Depending on which way I turn them, I have three different heights available. Definitely more useful than ramps.
 
I never trusted the ramps so I used the jack and stands until I bought a 4 post car lift. We use it to store the 2010 Camaro during the winter months. It gets a workout the rest of the year.
 
Back
Top