trailer lift

beaconlight

501 Club
John *.?-!.* cub owner what are the dimensions of the plate you mounted the lift to on your trailer? If I remember correctly you used a Pick-up truck type mounted lift?
Any one else with experience on this please chime in too.
Thanks
Bill
 
I don't have my trailer handy to measure right now, but here is a link to the hoist I used, though after using it for a while I did replace the winch with a sturdier one.
http://www.harborfreight.com/cpi/ctaf/d ... mber=37555

On my first trailer I put a plate slightly larger than the crane base, with some gussets extending down, and welded it to the side frame of the trailer just in front of the wheels. I then welded an 6 inch angle iron between the right and left trailer frame to reduce twisting. When I went to a bigger trailer I used an I beam welded across the bottom of the trailer frame. that proved to be a sturdier system.
 
John: Did the crane itself live up to your expectations as far as strength/quality? I was thinking of building one but for $100 why bother. Thanks Frank
 
yup, real happy with it, with the exception the winch was light. I bought a heavier winch from harbor freight, and a better cable from McMaster Karr.

trailer%20crane.jpg



house%20steps.jpg
 
Back
Top