Trail blazer AC

Jeff Silvey

501 Club
Had to change out my wifes battery in her 2003 trail blazer. AC worked great on the vents coming out dash. After changing battery no air out vent but every where else.
Its made the little lady upset. Can anyone help. Oh it blow at all speeds at any level except the vents.
Thanks
Jeff
 
My guess is:

Your climate control distribution box is all electric, none of the damper doors are vacuum or manually operated. Little electric motors open and close them, or at least there's one electric motor pulling a cable. The fan doesn't work unless the sensors indicate all the doors are in the proper positions. Seeing as how you just had an electrical failure with the battery, some sensor or switch or wire or door is loose, disconnected, obstructed or fried.

I hope it's easier to access than the older GM truck systems.
 
I’ve changed jobs and they have a computer room in which they let me eat lunch in. Maybe I can start catching up on things at Farmallcub.com. :D

In the rear fuse box (under the left rear seat, where the tire equipment is) check fuse 36 battery voltage all the time (HVAC B) and fuse 39 Battery voltage key on (HVAC 1). Fuse location is illustrated under fuse box lid decal.

If the fuses are ok you may have a logic lock from low voltage. A quick fix on that is; remove both battery cables from the battery and connect them together for 30 seconds to one minute. Make sure you have a good connection, sometimes that’s hard on those types of battery cable ends.

Note: Always remove battery cables; negative first and positive last. Always put battery cables back on; positive first and negative last.

If this doesn’t address the issue maybe I can help with further diagnosis.
 
Jack:
Thanks for the info but that didn't help.I talked to a local dealership they said there's three switch's or what ever you call them this day and age, that opens & close's the doors on the AC & heater. Two are easy the other one it hard to work on. One of these items could be bad. I haven't looked yet for a web site conaining the wireing scurmatic ( spelling). hope you know what I'm trying to say.

Jeff
 
First check your local library for the Chilton or Haynes repair manual for your vehicle. It will have the info you're looking for. Check eBay and Amazon if they don't have a copy because it doesn't hurt to have one on hand. Heck, get one of each! I prefer the manufacturer's repair books but they have gotten quite pricey, your owner's manual should have the ordering info in it.

http://www.amazon.com/Haynes-Chevro...58?ie=UTF8&s=automotive&qid=1186530815&sr=8-2

http://www.amazon.com/Chevrolet-Tra...8756958?ie=UTF8&s=books&qid=1186530890&sr=8-1
 
Jeff,

The diagnosis is a little complicated, but if you want to try it I’ll give you the information. I may not be able to get back to you until the weekend so to get started here is the partial flow chart for manual A/C. Auto A/C is very similar and I will send that if needed. Also there are variables in diagnosis depended in what options on your vehicle in which I’ll tell you how to get if you want to try this.

One thing I think you should try is the recalibration alternate method (w/o Scan Tool) I have written on the lower half of the document. I just can’t understand the mode actuator just stop working after a battery change. Let me know if I can help any more…. Good luck…

http://docs.google.com/Doc?id=dcpqrttm_160ckdjfr
 
First I want thank everyone for their help. Here's the out come.
Took it to a dealership. I was an acuator that opens the one door. R&R was 300.00 not bad in my book. Wife's happy PRICELESS. :D
Jeff
 
Back
Top