TO35 will not cut off

TomE

Well-known member
First, it died due to a shorted coil. The coil and resistor were replaced as well as the plug wires. Since the parts store does not carry parts for a 60 year old tractor I bought a coil and resistor that the counterman said would work. The resistor was for a '58 Corvette, so how could I go wrong?

This repair fixed the tractor so well now it will not cut off. I have to cut off the fuel to get it to stop. While I was at it, I repaired and replaced some of the ignition wires dues to the multitude of twisted splice repairs made over the years. All these wiring repairs followed the original wiring. This tractor was converted to a 12V with an altenator.

I have gone over this failure to cut off several times. I think a component is grounding out somewhere. I found today that the solenoid's bat terminal has about 50 ohms to the screw that secures it to the chassis. Could this be the culprit?
 
Couple of thoughts. 3 wire alternator? You may have removed the resister in the wire exciting the alternator when you rewired the tractor. Resistor removed will keep providing battery voltage to the ignition system.

Solenoid. With the ignition key off, there should be no voltage supplied to the solenoid. Does the solenoid have a terminal for plugging in the ignition system?

I would start with voltage check traces. OH, by the way, with voltage being supplied to the ignition system with the engine not running, burning points.
 
You were both right. The previous owners wiring had a green wire out of the alternator that was twisted to a wire that ran to the coil via the resistor. Thinking this was a bad connection, I replaced this wire and crimped it to the the wire beside the diode wire. I disconnected this line at the resistor today and we are now shutting down.

Thanks for you help. You two are better than the all the wiring diagrams for a TO-35 that you can find online (and that's a lot).
 
Back
Top