Tillotson YC6A carburetor

Don McCombs":jlp371k3 said:
A soak in Chem-Dip and a soda blast should clean it up nicely.
Yup, thanks Don. And the best part is I finally found one that would work :tractor: And I didn't have to refinance my house to get it. :lol:
 
This is a follow-up on this topic. I found and substituted a Tillotson YC7A carb, got all the parts freed up and a bracket made to compensate for the 5/16" mounting studs and a wider mounting spacing. I chose to make this from 1/4" flat stock (one for the carb mounting flange and one for the manifold mounting flange), and used countersunk cap screws to connect it together so the gaskets will seal. The entire assembly will be a LACubfest project to clean, adjust and test for satisfactory operation. Hopefully, this brings to a close an eight+ year search for a replacement carb. :D Stan
Tillotson YC7A installed.jpg
 
My reference lists the Leader D with the IXB-5 engine using a Tillotson YC-2B carburetor. I would guess any YC carburetor is about the same. The differences are probably no more than levers on the shafts and the jetting.
Just a note for anyone that's interested, Tillotson YC5A and YC6A carbs both share the same venturi ID openings and have flange mounting spaced the same as the C60 intake manifold. Specs that I have found reference the same maintenance and repair parts for both of them. The YC7A carb flange to manifold is wider (about 7/8 inch) amd the venturi ID is a bit larger but the remainder of the internal parts are the same according to parts listings.
 
Back
Top