This isn't working so well....

cowboy

501 Club
In the living room :roll: :wink:

This is my latest project. ARI 600 windgenerator. Hopefully I will have it setup outside in a week or two. I am kinda eager to see how well it actually works :!: I don't think it will repay my investment but I just classify it as a toy. And any power savings would be a +. Hopefully painting it 2150 IH red will make it work better :D

IMG_0091.JPG



IMG_0093.JPG


Billy
 
Billy;
You are not right. Your hat is on to tight :lol: :lol: Let your wife figure the thing out , oh she's not their. :wink: :wink:
Good Luck
Jeff
 
Billy, Looks like something I've wanted for a few years now. Before you put it up in the air, put it out in the backyard and fasten some corn ears to each blade end and have fun with the squirrels :D :D Got you thinkin' now, don't I :wink:

PM me the link to where you bought it.

Thanks Billy,
Rick
 
Jeff
Billy doesn't have a wife. That is why it is in the living room.

Billy what ever happened with the generator? Is it finished or is it UP?
Bill
 
I think I've got a solution to trying it out before you mount it :?: :idea:

You could host a "Mini-Fest" at your place, and with all the "Hot Air" we'd produce, we should be able to generate enough power to run your entire grid :shock:
 
Billy,

I was watching 'World's Dirtiest Jobs' yesterday (I think it was) and they had a segment on gandy dancers. That reminded me to tell Marilyn we have a set of tie tongs. I thought she should know in case she needed them. :shock:

I don't remember where I got them but the long, straight handles have been blacksmithed into loops very much like the pair hanging on your wall. Do you know what the prongs on the top side of yours are for?

Is your wind charger a 32 volt Delco?
 
George I believe the hooks are to snag into a tie in a pile to skid it enough to pick it with the tongs. When they are in a pile ypu don't have 2 sides to work with.
 
Rick and Jeff

Their are two main types of wind generators. Off grid and Grid tied

Off grid uses a windmill to charge a battery bank 12v 24v or 48v.
Then use a power inverter off the batterys to make 110v ac for use in the
house.

Grid tied make 110v output and ties strait into the house. These are
larger systems cost a lot more and need higher wind speeds to work. And
if the wind speed is two low do not work at all. General starting cost is
about $5,000.

My brother has been looking for over two years for a good wind
generator. Most of the ones he has seen are either way too expensive or
junk. Finally he found this ARI system. Air X is the main wind generator
out right now. The problem with it and the other wind mills out right now is
that to protect it from too high wind speeds it has a computer and linkage
on the tail fin that turns it out of the wind unfourtenly wear and turbulent
winds tend to break it. Also the blades are flexible so that in high winds
they flex so as not to catch so much air. But then it make a lot of noise and vibration.

The ARI uses a electromagnetic brake system solid tail fin and stiff blades.


I got the 600 watt 24v (750 watt max) ARI windmill for $748 with shipping.
With the ARI system you can also hook up up 200 watts of solar panels.

http://arisolarwind.com/estore/

Another impotent choice is the battery bank voltage. The choices are 12v
24v and 48v. The smaller the battery bank voltage the higher amprage it
draws to convert the battery voltage to 110v. To convert 3000 watts to
110v a 12v battery bank needs to put out 250 amps. At 24v 125 amps and
with a 48v battery 62.5 amps. Even though it is all the same amount of
power you need a lot bigger and more expensive wiring to hook everything up.
48v would seem to be the best but a 48v inverter is four
times the cost of a 12v or 24v inverter. I went with a 24v windmill battery
bank and inverter.

Batterys Don't even try to use a car battery it will not hold up for
this use. Deep cycle batterys only hold up 3 to 5 years and is not cost
effective. The best battery is a golf cart battery it has a large power out
put and will last around ten years. I got four six volt batterys for $66 at
sams club and will hook them up in series for 24v.

Power inverter. You need a power inverter big enough to supply
what ever you are going to power with it. (and enough battery power to
supply the inverter) I got a inverter big enough to power the whole house
except the 220v appliances (cloths dryer and well pump for me) I found a
good 5000 watt inverter that was only about $50 more than the 3500 watt
inverters which are the main large inverters right now. I got a Aims 24v
5000 watt inverter for $469 with shipping

This is the inverter and batterys for the battery bank. The battery off to the side is one out of a 91 ford explorer just to give a idea of the size.

IMG_0140.JPG


http://www.theinverterstore.com/the-inv ... -front-rgb

It really does not matter that my windmill cannot make all the power I can
use at one time. As long as I can recharge the batterys in 24 hrs what I
use during the day I am ok. I set up my out put side to supply what I need
to run my house. As I get the money I will add on one or two more wind
generators and some solar panels.

This is something I am thinking of getting. It is a remote battery monitor.
So I can check how much power is in the batterys how fast I am charging
and how much power I am using.

http://www.infinigi.com/bogart-engineer ... -1695.html

Water heating. When your batterys are full the windmill is still
making power. It has to get rid of this power or burn up. Usually this done
bu dumping the power into a resistor. But it can be connected to a low
voltage water heater element. They say 30% of home energy use is the
hot water heater. By using this heating element in your hot water heater
you can save money there too.

http://www.gaiam.com/product/code/25155 ... d=25155.do
 
Jeff that hat needs to be reformed its a little warped :wink: Then again I guess I am to but there's no reforming me at this point :oops:

Thanks Dan. The way things are going you will be seeing a lot more of them :D

Rick I don't have much problem with squirrels. I will be a happy man if I can chop up all of these starlings :!: Any :idea: what I can use for bait :?:

Bill the generator is waiting to the lean to on the garage to get done. Those flywheels scare me. I want to put a safety cage around it.

Mike my dad wanted me to mount it on the mule and drive it around and see if it worked :shock:

George I really don't know but I think they are ice tongs. I think the hooks on the back would be to pull the ice to where you could grab it with the tongs. I also have a big pair for lifting railroad ties. Bill you could be right. I found both of them in a scrap yard at the same time

Is your wind charger a 32 volt Delco?


NO I have seen those but this is a custom wound job in a cast aluminum housing.
 
Southwest Windpower also makes windmills. They were recommended to me by a friend that has been off the grid for 26 years (combination wind and solar). Haven't gotten any farther than reading their web site though.
 
Back
Top