I assume you are asking for your 200. First off, it isn't a single wire. It is a harness with 2 cables, one to power the rear light and another to ground it. It exits the instrument panel at the left lower corner, so it comes out below the lip of the platform and fairly near the clutch pedal. It runs under the platform with two retaining clips, one about even with the shift lever and the other somewhat behind the center line of the rear axle. When it gets to the back of the platform, it comes up around the rear lip then turns to the right to run across the top of the platform until to turns up to reach the lamp on the right side of the platform. There are two clips to hold it to the top of the platform, one on each side slightly outboard of the sides of the tool box.
