phantom wrote:
whew! most of that is same as greek to me.
Hi phantom,
After reading the comments here, i realize now some of the things i mentioned mighta been a little too technical. Because of the continuing comments by dialup users on this forum, my intent was truly to inform. I've worked in the modem industry for 15 years starting when 300 baud modems were 'state of the art' and the internet was years away! Broadband and satellite were just as far off.
In addition to designing the telco interfaces for dialup modems to work on domestic phone lines, i also had to deal with modems designed for foreign countries and get the design to pass some of their stringent regulatory tests. Japan was the worst!! I got to know phone systems real good so this stuff is second nature to me. I apologize if i've confused anyone here.
i knew a lil bit about 'puters back when all was done from the dos prompt, my own programs were written by me in basic,
The phone system as outdated and archaic as it is in most areas has more to do with simple electronics than computers and software.
I'm gonna geuss the 48 Volt battery might of confused some folks.
For anyone who has a basic understanding of electronics, here's very basically how a battery fits in with the two-wire Public phone system.
The audio portion of the phone signal is superimposed or rides on a DC loop current. The source of this DC voltage is a big old 48 Volt battery bank located in the central office(CO).
When the phone is ON-Hook meaning its just sitting there waiting for a call, there is no current (called loop current) from this battery flowing through the phone. Once a ring signal is sent to the phone from the CO (which by the way is normally a 20 Hz 90 Volt AC cadenced signal), the phone or modem detects this large AC voltage and closes a relay to complete the electrical DC path from the CO battery enabling a DC current to flow between the phone/modem and the CO. Once this relay closes the phone or modem is said to be OFF-hook. The CO senses that the phone/modem is OFF-Hook and starts superimosing audio signals on the DC loop current. If you put a DC voltmeter across the two wires coming into your house:
ON-Hook (or open circuit) DC voltage should read the battery voltage, normally anywhere from 48 to 52 Volts DC
OFF-Hook DC voltage (closed circuit) should read anywhere between a few volts DC to 8 or 9 volts depending on the phone/modem, the battery voltage, voltage drop across the line, etc.
Now a question for inquisitive, how does the phone system get two-way simultaneous audio data on just two wires?
Hope i didn't add more confusion!
-Ken