Serious About Firewood

  • Thread starter Thread starter Anonymous
  • Start date Start date
When firing a boiler with wood for radiant heat you need a reserve or holding tank with a vent for the water to expand. The heat from the wood is hard to control and the water in the boiler expands quickly and has to go somewhere quickly. My dad and I set one up years ago. After we got it set up it worked very well.

After about twenty five years of cutting wood, he switched to a ground source system in which the supply came from a nearby lake. You can dig wells next to the house for the supply also. Personally I think this is the future for our Heating and A/C needs. The investment is more on application, but if you’re going to stay in your home for tens years it will pay you back.

If the electricity in our country would be produced by nuclear means and all Heating and A/C needs in this country used the ground source system; via electricity produced by nuclear plants, you would have a surplus of fuel and natural gas products in minutes!

Some parts of the US have means of producing electricity by hydro. In Missouri we are fortunate to have both hydroelectricity and nuclear electricity generation.
 
Jack Fowler":3hhsm5gq said:
When firing a boiler with wood for radiant heat you need a reserve or holding tank with a vent for the water to expand. The heat from the wood is hard to control and the water in the boiler expands quickly and has to go somewhere quickly. My dad and I set one up years ago. After we got it set up it worked very well.

After about twenty five years of cutting wood, he switched to a ground source system in which the supply came from a nearby lake. You can dig wells next to the house for the supply also. Personally I think this is the future for our Heating and A/C needs. The investment is more on application, but if you’re going to stay in your home for tens years it will pay you back.

If the electricity in our country would be produced by nuclear means and all Heating and A/C needs in this country used the ground source system; via electricity produced by nuclear plants, you would have a surplus of fuel and natural gas products in minutes!

Some parts of the US have means of producing electricity by hydro. In Missouri we are fortunate to have both hydroelectricity and nuclear electricity generation.

Yes, Jack....

I believe in the case of my cousin's system, he circulates the water through his oil boiler, and lets that system deal with the expansion and circulating of heat through the house.

I, too think that ultimately, ground source heat pumps will be the way to go, but with so much of our electricity production still based upon fossil fuels, and particularly coal, nationwide, we cannot say that this is either clean or efficient at this point in time. (By efficient, I do not mean cost efficient, but rather carbon efficient.)

I am unsure what to think about natural gas.....we either use it, or waste it, for the most part....right now, there is such a huge demand for it, and it is the least destructive of fossil fuels, but all things considered, it would be better to leave it in the earth where it was. I think it is a shame to burn it in massive power plants, however, when it would be more efficiently used to heat homes, cook, and so forth right now.

Still, there will always be the question of what to do with all the dead-fall, and waste timber from the logging industry. Whether we leave it to rot, or use it for fuel, it still contributes the same amount of CO2 to the atmosphere. Using it as a fuel saves precious resources, and does not add additional CO2 (with the exception of a small amount for log-splitter and chain saw fuel) to the atmosphere. If people stopped using wood for fuel tomorrow, and we left all of our other fuel usages the same, we would find ourselves in deep trouble a lot sooner. The amount of wood that goes unused as fuel is always a concern to me, and I wish more people would at least supplement their heat with wood. I often have observed that nature can load up more CO2 into our atmosphere in the course of a single ice storm, that we can with our silly little motorcars. Of course getting the source and the use together is a difficult process that involves a lot of factors, and is the reason wood is not more widely used.
 
Jack I have been using a ground loop heat system for nearly 25 years, and really like it. Mine uses water lines buried under ground in loops near the house. Like you, I think it is the way to go. Initial cost was a little higher, but not much considering it also included air conditioning. Like you, I think it is the future for home heating.
 
Jack,

My ground source heat pump system is in its' 16th year. It's a bit unusual in that it doesn't use water in the lines. The 2000' of buried 1/4" copper tubing contains freon. I think it's the most efficient system available. It's called a DX system. It also does much of the water heating. One happy advantage... When in A/C mode the heat from cooling the air is used to heat water. :D

I satisfy my urge to build fires when I heat the shop with the airtight wood burner.
 
I just love alternative heating sources. Problem is, not yet have I heard of one that is reasonably priced. When you factor the almost triple price to buy and install it would take 30yrs to just break even with any convetional setup. It seems when the fuel to operate a system is free or cheap the equipment is outrageous. My neihbor just installed an add-on corn burner. It costs way more than my propane furnace w/heat pump and A/C. And that was just to suppliment. And he still has to buy the corn! The only reason I burn wood is the stove and wood are both free. I've just got my time in it.
 
It is my understanding that an ground water to air heat pump system's cost depend a lot on the source of the "water". My water in the well is more than 200 feet below the surface which means two wells (intake and discharge). The cost would be considerable. Or I could use the system developed by Oklahoma State University which has a closed loop. Still the size of my house would require two but the system would be less thna using ground water. But a friend of mine live very close to the Platte River and the ground water is only 8 feet below the surface, which he can reach with a sand point. His system cost just a bit more than the standard air to air heat pump. Pay back was less than a year.

Richard
 
John, my neighbor just bought a corn boiler the initial cost is about $5000 but the fuel cost for him is small . He will be using the corn out of his 300,000 bushel bins. Actually he bagged up the corn when he cleaned out the bins before this years harvest
 
Richard, my system is a closed loop buried underground. That system has been available for years. You can also have a closed loop inside a well. after it is installed and pressure tested, the well is filled with a special grout to improve heat conductivity. That only requires one well. Both of these run a mixture of alcohol and water.
 
Little Indy":1pubhhn0 said:
It is my understanding that an ground water to air heat pump system's cost depend a lot on the source of the "water". My water in the well is more than 200 feet below the surface which means two wells (intake and discharge). The cost would be considerable. Or I could use the system developed by Oklahoma State University which has a closed loop. Still the size of my house would require two but the system would be less thna using ground water. But a friend of mine live very close to the Platte River and the ground water is only 8 feet below the surface, which he can reach with a sand point. His system cost just a bit more than the standard air to air heat pump. Pay back was less than a year.

Richard

My system uses no water... anywhere, and the low operating cost has paid for the equipment many times over. The source of the heat is the ground itself. We don't heat and air condition the entire house, only about 3000 square feet of it. We are at the same lattitude as the center of NE.
 
George Willer: "My system uses no water... anywhere, and the low operating cost has paid for the equipment many times over. The source of the heat is the ground itself. We don't heat and air condition the entire house, only about 3000 square feet of it. We are at the same lattitude as the center of NE."

The principle is the same. Use mother earth as the source of calories to heat and as the place to dump calories to cool. I am not sure I understand the physics. This use of mother earth is certainly the wway to go for new contruction and any replacement. George what do you figure was the payback time? Was your present system for new contruction or replacment because the old system needed replacing? I wished the H/A contractor had told me about your system when I had to replace my heat central A/C about 5 years ago.

I think if I were to build a house today I would use something like your system for most of the H/A with a wood stove as backup because when we have one of the terrible Siberian Xpress blizzards we usually lose power for a while. Then the independent cuss I am thinks why not an addition with a Lister engine to furnish electric power and heat for radiant heat in the floor and maybe use a windmill generator as well. Well that is what I would do for new contruction out here in rural NE. I just hate thinking of my money going to those guys in the Middle East or South America.



Richard
 
My house is 1800sqft. Before wood heat supplement I could heat or cool for less than $100.00 a month. That includes electric and propane combined cost. There is just no way any alternative system is going to be cost effective enough to justify even the initial purchase price let alone operating costs. It would never ever pay itself back.
A friend of mine has geothermal. It was $10,000 to install. Minimul savings were realized and when he added on to his house that system didn't allow for expansion so he had to put in a second conventional setup. In the end it was a nightmare marrying the two together, I don't know if he ever got that straightened out, and I'm sure the projected savings went out the door.
 
Little Indy":3jsgibzf said:
I wished the H/A contractor had told me about your system when I had to replace my heat central A/C about 5 years ago.Richard
More than likely he didn't hanlde them, and wasn't aobut to send you else where. I don't think that ther are but 3 or 4 compnies that make the geothermal systems, os you have too look around for dealers that handle them.
 
Back
Top