Rust preventive

LiL' Red

501 Club
Had a real bad fire here yesterday, lost my workshop. What can I use as a rust preventive for the lathes, mill, planers etc while they are in storage?
 
Sorry to hear that Red

We used to use LPS-3 on crankshafts. It was kinda waxy and hard to get off but I haven't seen it around for a few years.

Billy
 
Sorry Red for the loss. If I had to do the same as you and wanted to protect metal on the machinery, I'd go buy some spray cans of this stuff ( http://www.rustoleum.com/CBGProduct.asp?pid=42 I first bought some when I put the dyno together. I wanted to keep the natural look on all the black pipe instaed of painting it. I sprayed a good heavy coat of this stuff on and it's lasted for a couple years so far. It dries and you can't tell it's on anything. It sprays on like WD or PB, but actually works and protects instead of evaporating completely.

Rick
 
Lil Red - I'm sorry to hear the news. I hope things work out OK. The stuff Rick mentioned is good stuff.
 
The rust preventer Rick mentioned is good, but it will have to be removed from working parts, such as bearings spindles, etc. when they are put back in use. Not sure how hard that would be on something like a lathe, etc. Many of the Teflon sprays are good, and if you can find the LPS, I have used it in the past and it is good. not cheap though.
 
Red, sorry to hear that. Glad you are OK.

As you can see, there are a lot of good products available. I prefer the silicon based sprays.

Good luck,
 
Bill:

I am really sorry to hear that. We shall keep you in our prayers. Hope that the tools aren't in storage for long. I personally use silicone and it has kept most of my tools rust free for years while I was recovering.
 
Back
Top