Removing the bolster question
- Thread starter ShawnAgne
- Start date
560Dennis
Member
How handy are you? Safety first.
I cut a + 12 inch diameter hardwood section from firewood log that is cut square to the length on both end s to set bell housing on . The base has a secure foundation for the tractor to set for a month or more, no soft dirt or concrete block s.
You can buy cribbing, and block square under the bell housing.
Safety,I don’t use hydraulic jacks for support . only to lift ing with Jack.
I use hydraulic engine crane to support and lift the front axle cause I do that myself. I front end will easily release wheels go left o right . You can’t hold it .you can get hurt real quick.
Lock both brake so the rear will not move . I chock the wheels for safety’s.
I cut a + 12 inch diameter hardwood section from firewood log that is cut square to the length on both end s to set bell housing on . The base has a secure foundation for the tractor to set for a month or more, no soft dirt or concrete block s.
You can buy cribbing, and block square under the bell housing.
Safety,I don’t use hydraulic jacks for support . only to lift ing with Jack.
I use hydraulic engine crane to support and lift the front axle cause I do that myself. I front end will easily release wheels go left o right . You can’t hold it .you can get hurt real quick.
Lock both brake so the rear will not move . I chock the wheels for safety’s.