John *.?-!.* cub owner
501 Club
I used to work as an appliance repairman, and every so often forget to take the same advice I used to give people. With time the outside coils on refrigerators accumulate dust and need to be cleaned, even the ones that are sold as dust free, and supposed to never need cleaning. The signs are running a lot, freezing ice slowly, especially in hot weather and ice cream being softer than usual. If you have one with the grill up the back it is easy, just wipe or vacuum the dust off. If the coils are under neath with a fan blowing across them it gets a little more involved. You will need a vacuum with a small inlet to reach underneath, a 1/4 inch socket or screwdriver, depending on the bolt type, and to do it right, probably an air tank with blow gun.
Turn the fridge off, and pull the toe plate off at the bottom. If it hasn't been cleaned in a while, you will see a big glob of house dust covering the coils as well as everything else under it. Use the vacuum to clean as much of that out as possible, then roll the unit away form the wall and remove the access panel at the bottom rear of the fridge. You will see the fan, rear of coil, etc. Put the vacuum hose under the front of the unit where you just vacuumed, and then close a wet towel in the door so it is hanging down to keep dust from blowing all over house. Then go to the rear and use the air tank with blow gun to knock the dust loose so the vacuum in the front will suck it in. The result will be a refrigerator that works better and uses considerably less electricity.
When moving the unit out from and back to the wall, be careful of the water line going to the ice maker, and also don't be surprised when you turn it back on to see more dust come blowing out form under it.
Turn the fridge off, and pull the toe plate off at the bottom. If it hasn't been cleaned in a while, you will see a big glob of house dust covering the coils as well as everything else under it. Use the vacuum to clean as much of that out as possible, then roll the unit away form the wall and remove the access panel at the bottom rear of the fridge. You will see the fan, rear of coil, etc. Put the vacuum hose under the front of the unit where you just vacuumed, and then close a wet towel in the door so it is hanging down to keep dust from blowing all over house. Then go to the rear and use the air tank with blow gun to knock the dust loose so the vacuum in the front will suck it in. The result will be a refrigerator that works better and uses considerably less electricity.
When moving the unit out from and back to the wall, be careful of the water line going to the ice maker, and also don't be surprised when you turn it back on to see more dust come blowing out form under it.