I have 2 recessed can light fixtures in the ceiling in one room. Whether I use an LED bulb or a incandescent bulb in one recessed can it goes out after 5 minutes then comes on after a couple minutes and the cycle repeats itself. After checking the simple stuff, I figured it must be a failing ballast.
I pulled the can out and in the electric connection box that the can is wired to I see a ballast or some type of resistor protruding from the connection box. When the light goes out, the ballast is too hot to touch.
My question are:
1.) I am using LED fixtures designed specifically to replace the original bulb. Do I actually need this ballast with a modern LED fixture or can I bypass it?
2.) If I need to replace the ballast, any idea what I need (other than to remove the old one and take it to the store)? Just a quick check online of “big box” stores I don’t see much.
3.) Any idea where I would buy this if it is needed? Maybe one of those places that sells resistors and electric components?
Thanks

I pulled the can out and in the electric connection box that the can is wired to I see a ballast or some type of resistor protruding from the connection box. When the light goes out, the ballast is too hot to touch.
My question are:
1.) I am using LED fixtures designed specifically to replace the original bulb. Do I actually need this ballast with a modern LED fixture or can I bypass it?
2.) If I need to replace the ballast, any idea what I need (other than to remove the old one and take it to the store)? Just a quick check online of “big box” stores I don’t see much.
3.) Any idea where I would buy this if it is needed? Maybe one of those places that sells resistors and electric components?
Thanks
