Pellet Stove Repair

I need some advice. A friend just bought a new pellet stove and I got the old one its not in bad shape and my plans are to use it in the shop. The problem is there is a crack in the front of the heat chamber, a very small one right above where the pellets drop. The stove ran with a co2 detector in the room where it was never set it off, they took the detector to the Fire Dept where it tested fine. I would still like to repair the crack was thinking of some furnace cement I do have a friend who can weld cast but don't think I want to go that route. The shop is far from air tight and is about 1400 sq. feet.
 
Sounds risky to me, furnace cement is not permanent it is mostly used to seal smoke pipes on oil fired units eventually it cracks and will leak ,,,,Id weld it
 
Your local hardware store should have furnace cement. At least in rural areas where wood is a common heat source. It is used to seal joints in cast iron or heavy sheet metal stoves and furnaces.

Pretty simple to use. Clean up the crack. Dampen the area. Press cement into the crack. Let dry completely before using. Also used like a thick gasket cement when assembling stove parts.
 
For shop use "mud it" and use it!--- it will last a long time! The outside air will enter your shop around the doors/windows in enough volume to be ok! thanks; sonny
 
Back
Top