Oil Consumption-94 Ranger

I have never done it on a car, but have on old tractors simply by adding Sea Foam to the oil and running a few hours, then draining, and it cleaned the sludge, etc. with no problems. and no plug ups.
 
Dan, I tqalked to a friend who is a mechanic at the local Ford dealer/ His suggestion was to used Seafoam on the top of the engine (suck in through an vaccum line and put it in the tank), as well asp out it in the oil, then drive it a while and change the oil.
 
John: With the info which you provided from the Ford mechanic, we have decided to postpone the reverse engine flush. Instead, this weekend we will do the Seafoam treatment, on top as well as in the oil. Maybe we will see a marked change in oil usage. If not, we can do the flush at a later time. Thanks again, Dan
 
This morning,my son did the Seafoam treatment through the carb as well as in the oil. He drove it for awhile, brought it home and did an oil change, discovering that there is an indication of previous leakage near the oil sending unit, a problem which I had said we did not have. The drained oil was extremely black, so a lot of carbon was removed. He installed diesel oil, will drive it a few days, then drain again. We will have the oil sending unit checked on Monday and replaced if needed. It will probably be 1-2 weeks before we can determine the effect on oil usage. I will let you know. Dan
 
I have had the same problem with several Chevrolets and some much older Fords. Mostly the valve seals failed, but I have dealt with stuck piston rings and some goofed-up vacuum lines and sensors failing as well. There may be a problem specific to the 4.0L engine. It takes a lot of oil being burned before it becomes apparent at the tailpipe.
 
Carl: We dropped it off at a repair shop yesterday afternoon to have the oil sending unit checked. They didn't have time to check it but should today. So, we should soon see if what has been done has eliminated or reduced the problem. Dan
 
Well, just received report from the repair shop. The rear main seal is leaking. Assuming that this is the only problem, earlier observations of no smoke, exhaust pipe not oily, not fouling plugs, very little oil build-up on right side of motor make sense. At the rate at which oil was disappearing, the truck should have, like a new dog in the community, marked every location in which it stopped. However, we were involved in flea market booths at that time and one lane of our two car garage was being used as an area to clean, repair, and paint items for the booths. So, the truck was usually parked outside on a grassy area. It will be a fairly expensive repair but very inexpensive when compared to what a motor rebuild would have cost. Thanks again for the many suggestions which were given. Dan
 
Well, a final report on the Ranger. I went by the garage to pick it up after being told that it had a leaking rear main seal. Since I wasn't prepared for the replacement of the seal at this time, a mechanic had moved the Ranger out of the shop and it had been sitting outside for a couple of hours before I arrived. I checked underneath and there wasn't any fresh oil on the pavement, not even one drop. So, there may be a leak at the rear main but, if so, it is an extremely tiny leak and is not a factor in the rapid oil usage. We next used an aggessive engine cleaner, let it run for 10-15 minutes followed by two oil changes. This seemed to have had a positive effect. Immediately before starting this journey, the truck had gone through a quart of oil in 150 miles. It now uses a quart in about 600 miles. So, that may be as good as we are going to get from the motor. Again, thanks for all of the advice. Dan
 
Back
Top