NOS Wallpaper

Jim Becker

Moderator
Staff member
No, this doesn't have anything to do with a computer screen, I mean real wallpaper.

I have done some remodeling in a bathroom and now I need to replace a little bit of wallpaper. I have plenty left over from when the original was put on, but that was many years ago. This is pre-pasted wall paper. I am not having much luck making it stick. I suspect the problem is related to the age of the paper.

First I tried the usual of putting it in the tray. I probably had it in the tray a lot longer than the time required in the instructions, but we're not talking minutes. It didn't stick at all.

I then experimented with a couple small pieces (maybe 2" square). I gave one just a quick dunk and slapped it on the wall. The other, I thoroughly sprayed with a squirt bottle of water. Both seemed to stick adequately, with the dunked one doing a bit better.

Since I know I couldn't possibly do a "quick dunk" of a whole sheet, I tried the squirt bottle on a whole sheet. It didn't do much better than the first big sheet. It tried to stick a little but not well enough.

Anyone have any suggestions on how to stick this stuff to the wall? Any secrets to working with aged wallpaper? The total area involved is less than 20 square feet, so normally impractical solutions are perfectly acceptable in this situation. I could go get some wallpaper paste (I guess you can still buy it!) but I don't know if it will work over the stuff that is already on the wallpaper. By the way, I did paint a coating of wall sizing on beforehand. Although at this point, I probably need to put a new layer on the section where I have tried twice.
 
Jim,

I always preferred to use paste. I always preferred to leave the choices of paper to others. When the paper showed up it was usually pre-pasted but I pasted it anyway. Never a problem but I think real paste works better.

The paste on the existing paper must all be the same age so I'd think you could apply paste over it and have it stick. My only concern would be biological.

Happy Birthday!
 
Jim,

I'm with George on this one! Just set up a long table, lay the paper face down, and slather new paste on the paper just as if it was not pre-pasted.

The only thing to watch for is flaking of the pre-paste...but it should dissolve as soon as you brush on the good stuff. You've got the consistency of the new-fangled paste just right when it's like smooth apple sauce...and slimy-sticky!

My better half and I have probably hung miles of wallpaper together over the years. And she's still with me after 32 years, so I guess I haven't driven her too crazy...yet! :wink:

Good luck, and Merry Christmas to all!

Corky/Charles
 
I have a co worker who is a paper hanger his advice is also get some paste. He too does not feel pre pasted stands or should I say sticks up.
 
I got some paste and gave it another try. I still had some trouble, but that was probably just wallpaper and me. I'm calling it good enough. Another room done.

Thanks everyone for the advise.
 
3M spray adhesive.....give the wall a spritz and the back of the paper. Slap it up on there and trim to fit.

(Pray you never need to remove it) :)
 
I just has to remove the old wallpaper on one wall in the old house put up by the PO owner 32 years ago. They must have used the wrong glue, no wonder why it looked great for so many years. Well i don't like working with wallpaper. The sheetrock outer paper came off with it in some spots while using the steamer too. My wife is a cracker jack at muddin and she went over the whole wall fixin every spot the best she could. Then sanded it with a power sander.

My point is use the right glue because you may want to remove it someday...
 
Back
Top